From a Windows command prompt, which command displays
the local IP address of a computer?
A. ipconfiguration
B. ip configuration
C. ipconfig
D. ip config correct answer: ipconfig
Which set of steps best describes how to assign a static IP
address to the Ethernet port on a computer?
A. From the Network and Sharing Center, click Internet
Protocol (TCP/IP), and follow the New Connection Wizard
instructions.
B. From the Network and Sharing Center, click Change adapter,
then double-click a local area connection. Select Internet
Protocol (TCP/IP) > Properties > Use the Following Address,
and then configure the IP information.
C. Click Start. Enter cmd and click OK. Enter the IP address
XXX.XXX.XXX.XXX.
D. From the Network and Sharing Center, double-click Local
Area Connection. Select Properties >
iPass Protocol (IEEE 802.1x) > Properties > Static IP. correct
answer: From the Network and Sharing Center, click Change
adapter, then double-click a local area connection. Select
Internet Protocol (TCP/IP) > Properties > Use the Following
Address, and then configure the IP information.
Which type of physical connector does a Gigabit Ethernet port
typically use?
A. RJ-9
B. RJ-45
C. DB-25
D. RJ-11 correct answer: RJ-45
Which two IPv4 addresses can be assigned to a host computer?
(Choose two.)
A. 255.255.255.255
B. 10.1.1.20
C. 0.0.0.0
D. 192.168.10.15
E. 292.10.3.4 correct answer: 10.1.1.20
192.168.10.15
Which type of memory stores the configuration of a router or
switch by default?
A. RAM
B. ROM
C. NVRAM
D. flash correct answer: RAM
Which two statements about Telnet and SSH are true? (Choose
two.)
A. SSH is a protocol that provides a secure remote access
connection to network devices.
B. SSH uses the well-known TCP port 23 for its communication.
C. A Telnet network management connection is dropped when a
router reboots.