{"id":112929,"date":"2023-08-15T21:27:03","date_gmt":"2023-08-15T21:27:03","guid":{"rendered":"https:\/\/learnexams.com\/blog\/?p=112929"},"modified":"2023-08-15T21:27:05","modified_gmt":"2023-08-15T21:27:05","slug":"ase-a6-exam-latest-2023-2024-actual-exam-questions-and-correct-answers-with-rationales-verified-answers-agrade","status":"publish","type":"post","link":"https:\/\/www.learnexams.com\/blog\/2023\/08\/15\/ase-a6-exam-latest-2023-2024-actual-exam-questions-and-correct-answers-with-rationales-verified-answers-agrade\/","title":{"rendered":"ASE A6 EXAM LATEST 2023-2024 ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS WITH RATIONALES (VERIFIED ANSWERS) |AGRADE"},"content":{"rendered":"\n<p class=\"wp-block-paragraph\">ASE A6 EXAM LATEST 2023-2024 ACTUAL EXAM<br>QUESTIONS AND CORRECT ANSWERS WITH RATIONALES<br>(VERIFIED ANSWERS) |AGRADE<\/p>\n\n\n\n<ol class=\"wp-block-list\">\n<li>The condition of a lead-acid battery is being checked. Tech A says to use a<br>galvanometer.. Tech B says to use a capacitive battery tester.<br>A. Tech A only<br>B. Tech B only<br>C. Both A and B<br>D. Neither A or B &#8211; ANSWER- B- A galvanometer is an analog type voltmeter.<br>OEMs almost universally recommend the use of a non intrusive conductive<br>capacitive type battery tester.<\/li>\n\n\n\n<li>While testing a starting circuit on a 5.7 V8 engine, the Tech finds that the engine<br>cranks slowly. The starter current draw is 90 amps, and the battery voltage while<br>cranking is 11 volts. What should the Tech Do next?<br>A. Check for voltage drop of the starter motor circuit.<br>B. Test the battery capacity.<br>C. Replace the starter motor, as a short is indicated.<br>D. Determine the condition of the engine. &#8211; ANSWER- A- if an engine cranks<br>slowly and the starter current draw is only 90 amps and the voltage is as high as 11<br>volts, the tech should next check for excessive voltage drop in the starter motor<br>circuit.<\/li>\n\n\n\n<li>Tech A says that a noisy alternator could be caused by a bad diode. Tech B says<br>that noisy alternator could be caused by a worn bearing. Who is right?<br>A. Tech A only<br>B. Tech B only<br>C. Both A and B<br>D. Neither A or B &#8211; ANSWER- C- Both techs are correct, worn alternator bearings<br>and\/or a bad alternator diode will cause the alternator to be noisy.<\/li>\n\n\n\n<li>The analog ohmmeter needle does not move when connected to both sides of the<br>rotor. This means the rotor winding is?<br>A. Shorted<br>B. Grounded<br>C. Complete<br>D. Open &#8211; ANSWER- D- if the circuit is open, as in the rotor winding shown, the<br>Ohmmeter will show infinite resistance or infinity, and the needle will not move.<\/li>\n\n\n\n<li>A vehicle&#8217;s turn signals flash too slowly. tech A claims that the condition could<br>be caused by a faulty flasher. Tech B says that a bulb may be the wrong type. Who<br>is right?<\/li>\n\n\n\n<li>An air bag system is being serviced. Tech A says to disconnect the yellow SRS<br>connectors at the front of the vehicle. Tech B says to disconnect and isolate the<br>negative battery cable. Who is right?<br>A. Tech A only<br>B. Tech B only<br>C. Both A and B<br>D. Neither A or B &#8211; ANSWER- B- Always disconnect the ne the negative battery<br>cable and wrap with tape so contract cannot be made. Follow the specific vehicle&#8217;s<br>disarming instructions, as some SRS system can retain back up power for an<br>additional period of time.<br>7.Always disconnect negative battery terminal &#8211; ANSWER8. Which of these should be used when soldering electrical wiring connections?<br>A. Rosin Core Flux<br>B. Acid core Flux<br>C. Sulfur Core Flux<br>D. none of the above. &#8211; ANSWER- A- for best results and less corrosion at the<br>solder point, a rosin core flux should be used.<\/li>\n\n\n\n<li>When testing computer controlled systems, a digital multi-meter should be used<br>with an input impedance of at least:<br>A. 10k ohms<br>B. 100k ohms<br>C. 1 megohm<br>D.10 megohms &#8211; ANSWER- D- For maximum protection to the computer<br>controlled system of any electronic circuit, it is best to use at least a 10 megohm<br>impedance digital multimeter.<\/li>\n\n\n\n<li>When troubleshooting a slow drain on the battery, which of these diagnostic<br>tools should be used?<br>A. Ohmeter<br>B. ammeter<br>C. voltmeter<\/li>\n<\/ol>\n\n\n\n<p class=\"wp-block-paragraph\">D. Test light &#8211; ANSWER- B- always use an ammeter of a low amperage amp<br>clamp with your DMM to troubleshoot a slow drain in an electrical circuit&gt;<br>A. Tech A only<br>B. Tech B only<br>C. Both A and B<br>D. Neither A or B &#8211; ANSWER- C- Both techs are right. Both an improperly rated<br>flasher and an incorrect wattage bulb can cause the turn signals to flash at incorrect<br>intervals<\/p>\n\n\n\n<ol class=\"wp-block-list\" start=\"11\">\n<li>Tech A says a short circuit to ground in a circuit will decrease resistance. Tech<br>B says a short circuit will increase current flow. Who is right?<br>A. Tech A only<br>B. tech B only<br>C. Both A and B<br>D. Neither A or B &#8211; ANSWER- C- Both techs are right. A short to ground has little<br>or no resistance. Current flow increases as resistance decreases.<\/li>\n\n\n\n<li>When using a voltmeter to check for voltage in a circuit, the voltmeter should<br>first be connected to check for:<br>A. Source voltage.<br>B. excessive resistance<br>C. excessive amperage.<br>D. Good ground &#8211; ANSWER- A- A voltmeter should first be used to see if the<br>circuit is getting power before doing further tests.<\/li>\n\n\n\n<li>When checking the green eye of a sealed maintenance free battery, no color<br>seen indicates that the battery is:<br>A. undercharged<br>B. charged properly.<br>C. Overcharged.<br>D. Damaged. &#8211; ANSWER- A- if the so called Green eye is not visible, the green tip<br>of the built in hydrometer is not floating high enough in the electrolyte to be<br>visible. A fully charged battery will cause the built in hydrometer to float to the top<br>of the electrolyte and allow the green tip of it to be seen.<\/li>\n\n\n\n<li>Both headlights on a vehicle are dim on high beam but are normal on low<br>beam. Tech A says that a poor headlight ground could be the cause Tech B says<br>that a shorted headlight switch could be the cause. Who is right?<br>A. Tech A only<br><\/li>\n<\/ol>\n","protected":false},"excerpt":{"rendered":"<p>ASE A6 EXAM LATEST 2023-2024 ACTUAL EXAMQUESTIONS AND CORRECT ANSWERS WITH RATIONALES(VERIFIED ANSWERS) |AGRADE D. Test light &#8211; ANSWER- B- always use an ammeter of a low amperage ampclamp with your DMM to troubleshoot a slow drain in an electrical circuit&gt;A. Tech A onlyB. Tech B onlyC. Both A and BD. Neither A or B [&hellip;]<\/p>\n","protected":false},"author":1,"featured_media":0,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"site-sidebar-layout":"default","site-content-layout":"","ast-site-content-layout":"default","site-content-style":"default","site-sidebar-style":"default","ast-global-header-display":"","ast-banner-title-visibility":"","ast-main-header-display":"","ast-hfb-above-header-display":"","ast-hfb-below-header-display":"","ast-hfb-mobile-header-display":"","site-post-title":"","ast-breadcrumbs-content":"","ast-featured-img":"","footer-sml-layout":"","ast-disable-related-posts":"","theme-transparent-header-meta":"","adv-header-id-meta":"","stick-header-meta":"","header-above-stick-meta":"","header-main-stick-meta":"","header-below-stick-meta":"","astra-migrate-meta-layouts":"default","ast-page-background-enabled":"default","ast-page-background-meta":{"desktop":{"background-color":"","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""},"tablet":{"background-color":"","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""},"mobile":{"background-color":"","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""}},"ast-content-background-meta":{"desktop":{"background-color":"var(--ast-global-color-5)","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""},"tablet":{"background-color":"var(--ast-global-color-5)","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""},"mobile":{"background-color":"var(--ast-global-color-5)","background-image":"","background-repeat":"repeat","background-position":"center center","background-size":"auto","background-attachment":"scroll","background-type":"","background-media":"","overlay-type":"","overlay-color":"","overlay-opacity":"","overlay-gradient":""}},"footnotes":""},"categories":[25],"tags":[],"class_list":["post-112929","post","type-post","status-publish","format-standard","hentry","category-exams-certification"],"_links":{"self":[{"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/posts\/112929","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/comments?post=112929"}],"version-history":[{"count":0,"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/posts\/112929\/revisions"}],"wp:attachment":[{"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/media?parent=112929"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/categories?post=112929"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.learnexams.com\/blog\/wp-json\/wp\/v2\/tags?post=112929"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}