{"id":118073,"date":"2023-09-02T08:27:19","date_gmt":"2023-09-02T08:27:19","guid":{"rendered":"https:\/\/learnexams.com\/blog\/?p=118073"},"modified":"2023-09-02T08:27:20","modified_gmt":"2023-09-02T08:27:20","slug":"mssc-maintenance-awareness-exam-2023-2024-actual-exam-300-questions-and-correct-detailed-answers-with-rationales-verified-answersagrade","status":"publish","type":"post","link":"https:\/\/www.learnexams.com\/blog\/2023\/09\/02\/mssc-maintenance-awareness-exam-2023-2024-actual-exam-300-questions-and-correct-detailed-answers-with-rationales-verified-answersagrade\/","title":{"rendered":"MSSC MAINTENANCE AWARENESS EXAM 2023-2024 ACTUAL EXAM 300 QUESTIONS AND CORRECT DETAILED ANSWERS WITH RATIONALES (VERIFIED ANSWERS)|AGRADE"},"content":{"rendered":"\n

MSSC MAINTENANCE AWARENESS EXAM 2023-2024
ACTUAL EXAM 300 QUESTIONS AND CORRECT DETAILED
ANSWERS WITH RATIONALES (VERIFIED
ANSWERS)|AGRADE
Because of its design, an offset chain does not require a connecting link.
For this reason, it is normally used in? – ANSWER- Heavy load and low
speed applications
Multiple strand chains are used? – ANSWER- To transmit a great deal of
power
Compared to a V-belt drive, a chain drive? – ANSWER- Is more
efficient
In the process of installing a chain drive system, the motor and driven
component should be checked for a soft foot condition and excessive
run-out. The shaft run-out should be no more than? – ANSWER- 0.002
Chain sag is measured by rotating the sprockets so there is little or no
chain sag in the _ side and measuring the sag in the side. –
ANSWER- Taut, slack
A chain should be replaced when its length becomes __<\/em><\/strong> longer than
the original length. – ANSWER- 3%
Chain sag is measured? – ANSWER- Midway between the sprockets<\/p>\n\n\n\n

A special link used to reconnect a chain is called a _<\/strong> link. –
ANSWER- Master
A chain puller is a tool used to hold two ends of a chain together while
the? – ANSWER- Master link is installed
When using a chain puller, the jaws are opened and closed by? –
ANSWER- A dial on top of the tool
The three components for a belt drive system are? – ANSWER- Belt,
driver sheave, driven sheave
Pitch is defined as the distance between a point and a? – ANSWERSimilar corresponding point
The pitch circle of a belt drive is? – ANSWER- The place in the belt
which represents the center of the force being transmitted by the belt
A belt drive having a 12 inch driver pulley and a 6 inch driven pulley
has a pulley ratio of? – ANSWER- 0.5
In the calculation of shaft speed and shaft torques of a belt drive system,
which of the following applies? – ANSWER- Shaft speeds are inversely
proportional to pitch diameters<\/p>\n\n\n\n

The driven pulley in the belt drive system show is rotating at _<\/strong> rpm.<\/p>\n\n\n\n