ASVAB AUTO AND SHOP INFORMATION EXAM QUESTIONS

PDF Download

ASVAB AUTO AND SHOP INFORMATION EXAM QUESTIONS

Actual Qs and Ans - Expert-Verified Explanation -Guaranteed passing score -21 Questions and Answers

-Format: Multiple-choice / Flashcard

Question 1: Which tool might replace a hacksaw for some jobs?

Answer:

An oxyacetylene cutting torch

Question 2: If the difference ratio is 3 to 1,

Answer:

Three turns of the driveshaft produce one turn of the wheel Question 3: If an engine with conventional ignition runs rough, what might you you adjust on the on the breaker points?

Answer:

The gap Question 4: If you hear a loud clanking noise from the rear of a rear-wheel-drive, front-engine car, you should look for trouble at

Answer:

The differential or driveshaft Question 5: One important difference between front-wheel drive and rear-wheel drive is that in front-wheel drive,

Answer:

The driving wheels also steer

Question 6: Which is the correct sequence in a four-cycle internal-combustion engine?

Answer:

Intake, compression, power, exhaust Question 7: When a manual transmission is in a "direct-drive" gear, one revolution of the engine produces

Answer:

One revolution of a driveshaft

Question 8: Which of the following would not loosen a frozen nut

Answer:

Dousing it in ice water Question 9: If you suspect that not enough gasoline is entering the engine, what might you check first?

Answer:

Fuel system Question 10: If one engine cylinder doesn't work right, you should check for problems in the

Answer:

Ignition or fuel system

Question 11: If the exhaust valve does not open,

Answer:

Burned gas cannot leave the cylinder, and the engine will not run Question 12: It helps to hit a larger chisel with a bigger hammer because the hammer is

Answer:

More massive

Question 13: What must happen before the starter motor is engaged?

Answer:

The starter relay must be closed

Question 14: What is not an advantage of a sharp drill bit?

Answer:

It creates a smaller amount of chips

Question 15: A plywood-cutting blade for a circular saw

Answer:

Has many small teeth, to reduce splintering

Question 16: If tire pressure gets low, what will happen?

Answer:

The tire will lose its shape and create extra friction, reducing gas mileage and possibly overheating the tire.

Question 17: What is a poor use for a claw hammer

Answer:

Driving screws Question 18: A plumb line makes what kind of angle where it intersects a level line

Answer:

Square

Question 19: When choosing a slot screwdriver

Answer:

Make the blade as long as the screw head

Question 20: Which of these tools does not start to clamp until you turn it?

Answer:

Pipe wrench

Question 21: Plywood is better than regular wood for a subfloor mainly because

Answer:

It is stronger