.png){kind=logo}
PDF Download
CARPENTRY: MODULE 2 TEST
Actual Qs and Ans - Expert-Verified Explanation -Guaranteed passing score -39 Questions and Answers
-Format: Multiple-choice / Flashcard
Question 1: When calculating the amount of concrete needed, the unit of measure is
Answer:
cubic yards Question 2: The adhesive that requires two components that are mixed together at the time of use is
Answer:
Epoxy Question 3: Which of the following types of sheet material is used in high-wear applications such as concrete forms, cabinets, and countertops?
Answer:
HDO Question 4: An engineered wood product commonly used to make doors and other millwork is
Answer:
LSL Question 5: The type of hardboard that is coated with oils and resins during its manufacture is
Answer:
Tempered hardboard
Question 6: Which of these statements about pressure-treated lumber is not true?
- It is often used to make landscape timers
- Scrap material should be burned
- Eye protection and a dust mask must be worn when cutting it.
- It is less expensive than redwood
Answer:
- It is less expensive than redwood
Question 7: If a lag screw's head will rest directly on wood when installed, use a
Answer:
Flat washer
Question 8: Material-handling accidents are most likely to happen when
Answer:
Workers are new or inexperienced at a job
Question 9: The nominal dimensions of a typical concrete masonry unit are
Answer:
- x 8 x 16 inches
Question 10: In construction, the most common fasteners used for attaching two pieces of lumber are
Answer:
nails Question 11: An action that will not reduce your chance of getting injured on the job site is to
Answer:
disregard safety rules Question 12: How many board feet are there in thirty 2" x 10" x 15' joists?
Answer:
750
Question 13: A piece of lumber 3" in thickness and 8" wide would be described by which of these grading classifications?
Answer:
Joists and planks Question 14: The type of staple point that clinches outward after it penetrates the material is the
Answer:
Inside Chisel
Question 15: The term S-GRN means that the lumber
Answer:
Has a moisture content over 19 percent Question 16: Nail lengths are expressed in penny designations; the symbol used to represent penny is
Answer:
d
Question 17: A fastener that is very good for wallboard insulation is the
Answer:
Divergent staple Question 18: How many 4' x 8' sheets of plywood would be needed to provide subfloor for a 25' by 30' room?
Answer:
24
Question 19: A glulam beam consists of
Answer:
solid, kiln-dried lumber glued together
Question 20: Portland cement is usually packaged
Answer:
in paper bags holding one cubic foot
Question 21: Which of the following is not a mission of the Occupational Safety and Health Administration (OSHA)?
- Saving lives
- Establishing prevailing wages
- Preventing injuries
- Protecting the health of America's workers
Answer:
Establishing prevailing wages
Question 22: In a tree, growth takes place in the
Answer:
Cambium Layer Question 23: Which of the anchoring devices listed below is not used in solid masonry?
Answer:
Wedge anchor Question 24: Plywood that is typically used to manufacture doors, furniture, and cabinets is known as
Answer:
Hardwood plywood Question 25: Plywood layers (plies) with grain at right-angles to the core are called
Answer:
Crossband
Question 26: Ten-guage steel studs are classified as
Answer:
structural steel studs
.png)