CCNA 200-301 DUMPS FULL QUESTIONS - EXAM STUDY

PDF Download

CCNA 200-301 DUMPS FULL QUESTIONS - EXAM STUDY

GUIDE & FREE Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -100 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation

Question 1: C. Full

Answer:

An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?

Question 2: D. The link becomes a trunk port.

Answer:

Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable. What is the result of this configuration?

Question 3: B. It minimizes spanning-tree convergence time

Answer:

What is the primary effect of the spanning-tree portfast command?

Question 4: B. SDKs that support interaction with third-party network equipment

• REST APIs that allow for external applications to interact natively with Cisco DNA Center

Answer:

Which two capacities of Cisco DNA Center make it more extensible? (Choose two)

Question 5: C.

interface FastEthernet 0/1 channel-group 1 mode desirable switchport trunk encapsulation dot1q switchport mode trunk interface FastEthernet 0/2 channel-group 1 mode desirable switchport trunk encapsulation dot1q switchport mode trunk

Answer:

Refer to the exhibit. A network administrator is configuring an EtherChannel between SW1 and SW2.The SW1 configuration is shown. What is the correct configuration for SW2?

Question 6: A. OpenFlow

B. NETCONF

Answer:

What are two southbound APIs? (Choose two )

Question 7: D. show cdp neighbor

Answer:

Refer to the exhibit. Which command provides this output?Question 8: D. 2031:0:130F::9C0:876A:130B

Answer:

Which IPv6 address is valid?Question 9: A. The two routers share a virtual IP address that is used as the default gateway for devices on the LAN.

• The two routers negotiate one router as the active router and the other as the standby router.

Answer:

Which two outcomes are predictable behaviors for HSRP? (Choose two)

Question 10: A. reduced operational costs

• faster changes with more reliable results

Answer:

What are two benefits of network automation? (Choose two) Question 11: D. It uses a shared virtual MAC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN.

Answer:

How does HSRP provide first hop redundancy?

Question 12: C. Internal EIGRP

Answer:

R1 has learned route 192.168.12.0/24 via IS-IS. OSPF, RIP. and Internal EIGRP Under normal operating conditions, which routing protocol is installed in the routing table?Question 13: A. Spanning tree may fail to detect a switching loop in the network that causes broadcast storms.

Answer:

Which result occurs when PortFast is enabled on an interface that is connected to another switch?Question 14: D. A leaf switch can be added with connections to every spine switch.

Answer:

In Which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?

Question 15: A. CPU ACL

Answer:

Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?Question 16: C. Authentication identifies and verifies a user who is attempting to access a system, and authorization controls the tasks the user can perform.

Answer:

What is the primary different between AAA authentication and authorization?

Question 17: D. interface e0/0description to HQ-A370:98968ip address 209.165.201.2

255.255.255.252

Answer:

An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

Question 18: C. It cannot send packets to 10.10.13.128/25.

Answer:

Refer to the exhibit. If OSPF is running on this network, how does Router 2 handle traffic from Site B to 10.10.13.128/25 at Site A?Question 19: D. FF00::/8

Answer:

Which IPv6 address block sends packets to a group address rather than a single address?Question 20: B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.

• The router calculates the feasible distance of all paths to the destination route.

Answer:

Which two actions influence the EIGRP route selection process? (Choose two) Question 21: A. The floating static route must have a higher administrative distance than the primary route so it is used as a backup.

Answer:

When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?

Question 22: C. metric

Answer:

A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?

Question 23: D. SSID

• Profile name

Answer:

Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN