CCNA 201 - 300 EXAM QUESTIONS

PDF Download

CCNA 201 - 300 EXAM QUESTIONS

Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -100 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation

Question 1: What is a difference between local AP mode and FlexConnect AP mode?

Answer:

• Local AP mode creates two CAPWAP tunnels per AP to the WLC

Question 2: Refer to the exhibit. Which path is used by the router for internet traffic?

Answer:

C. 0.0.0.0/0

Question 3: Refer to the exhibit. Which configuration on RTR-1 denies SSH access from PC-1 to any RTR-1 interface and allows all other traffic?

Answer:

B.access-list 100 deny tcp host 172.16.1.33 any eq 22access-list 100 permit ip any any line vty 0 15access-class 100 in

Question 4: Which function does an SNMP agent perform?

Answer:

• it sends information about MIB variables in response to requests from the NMS

Question 5: What are two purposes of launching a reconnaissance attack on a network?(Choose two.)

Answer:

• to gather information about the network and devices

• to scan for accessibility

Question 6: Refer to the exhibit. Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?

Answer:

D. 10.10.225.32 255.255.255.224

Question 7: What is an advantage of Cisco DNA Center versus traditional campus device management?

Answer:

• It supports numerous extensibility options including cross-domain adapters and third-party SDKs.

Question 8: What are two descriptions of three-tier network topologies? (Choose two)

Answer:

• The network core is designed to maintain continuous connectivity when devices fail.
• The distribution layer runs Layer 2 and Layer 3 technologies

Question 9: Refer to the exhibit. An administrator configures four switches for local authentication using passwords that are stored in a cryptographic hash. The four switches must also support SSH access for administrators to manage the network infrastructure. Which switch is configured correctly to meet these requirements?

Answer:

C. SW3

Question 10: Refer to the exhibit. An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1.The new circuit uses eBGP and teams the route to VLAN25 from the BGP path. What is the expected behavior for the traffic flow for route 10.10.13.0/25?

Answer:

• Route 10.10.13.0/25 is updated in the routing table as being learned from interface Gi0/1.

Question 11: Refer to the exhibit. An engineer deploys a topology in which R1 obtains its IP configuration from DHCP. If the switch and DHCP server configurations are complete and correct. Which two sets of commands must be configured on R1 and R2 to complete the task?(Choose two)

Answer:

B.R2(config)# interface gi0/0R2(config-if)# ip helper-address 198.51.100.100 C.R1(config)# interface fa0/0R1(config-if)# ip address dhcpR1(config-if)# no shutdown

Question 12: How does Cisco DNA Center gather data from the network?

Answer:

• Network devices use different services like SNMP, syslog, and streaming telemetry to send data to

the controller Question 13: Refer to the exhibit. An administrator configures the following ACL in order to prevent devices on the 192.168.1.0 subnet from accessing the server at 10.1.1.5: Where should the administrator place this ACL for the most efficient use of network resources?

Answer:

• inbound on router A Fa0/0

Question 14: Refer to the exhibit. What action establishes the OSPF neighbor relationship without forming an adjacency?

Answer:

• modify hello interval

Question 15: Refer to the exhibit. Router R1 Fa0/0 cannot ping router R3 Fa0/1. Which action must be taken in router R1 to help resolve the configuration issue?

Answer:

• configure a static route with 10.10.10.2 as the next hop to reach the 20.20.20.0/24 network

Question 16: Refer to the exhibit. Which two commands were used to create port channel 10?(Choose two.)

Answer:

• int range g0/0-1channel-group 10 mode active
• int range g0/0-1channel-group 10 mode passive

Question 17: What event has occurred if a router sends a notice level message to a syslog server?

Answer:

• An interface line has changed status

Question 18: Refer to the exhibit. What is the next hop address for traffic that is destined to host

10.0.1.5?

Answer:

C. 10.0.1.50

Question 19: What are two differences between optical-fiber cabling and copper cabling?(Choose two)

Answer:

• Light is transmitted through the core of the fiber
• The glass core component is encased in a cladding

Question 20: Which function dose the range of private IPv4 addresses perform?

Answer:

• allow multiple companies to each use the same address without conflicts

Question 21: An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of three addresses 192.168.3.1, 192.168.3.2, 192.168.3.3 . Which configuration should be used?

Answer:

C.enableconfigure terminalip nat pool mypool 192.168.3.1 192.168.3.3 prefix-length 30access-list 1 permit 10.10.0.0 0.0.0.255ip nat inside source list 1 pool mypoolinterface g1/1ip nat insideinterface g1/2ip nat outside Question 22: How do AAA operations compare regarding user identification, user services and access control?

Answer:

• Authentication identifies users and accounting tracks user services

Question 23: Which goal is achieved by the implementation of private IPv4 addressing on a network?

Answer:

• provides an added level of protection against Internet exposure