FREE AND STUDY GAMES ABOUT 3 AIRCRAFT FINISHES

PDF Download

FREE AND STUDY GAMES ABOUT 3 AIRCRAFT FINISHES

EXAM QUESTIONS

Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -15 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation Question 1: When humidity is low, what is likely to occur if unhydrated wash primer is applied to unpainted aluminum and then, about 30 to 40 minutes later, a finish topcoat is applied?

Answer:

Corrosion.Question 2: Which type of coating typically includes phosphoric acid as one of its components at the time of application?

Answer:

Wash primer.

Question 3: Which statement is true regarding paint system compatibility?

Answer:

Old wash primer coats may be overcoated directly with epoxy finishes.Question 4: Before applying a protective coating to any unpainted clean aluminum, you should

Answer:

avoid touching the surface with bare hands.

Question 5: Which defect in aircraft finishes may be caused by adverse humidity, drafts, or sudden changes in temperature?

Answer:

Blushing.

Question 6: What is the usual cause of runs and sags in aircraft finishes?

Answer:

Too much material applied in one coat.Question 7: Which properly applied finish topcoat is the most durable and chemical resistant?

Answer:

Polyurethane.Question 8: Which of the following is a hazard associated with sanding on fabric covered surfaces during the finishing process?

Answer:

Static electricity buildup.

Question 9: Aluminum pigment in dope is used primarily to

Answer:

reflect ultraviolet from the fabric.

Question 10: Fungicidal dopes are used in aircraft finishing as the

Answer:

first coat to prevent fabric rotting and are applied thin enough to saturate the fabric.Question 11: When humidity is low, what is likely to occur if hydrated wash primer is applied to unpainted aluminum and then, 30 to 40 minutes later, a finish top coat is applied?

Answer:

A glossy, blush-free finish.

Question 12: A correct use for acetone is to

Answer:

remove grease from fabric.

Question 13: What is used to slow the drying time of some finishes and to prevent blush?

Answer:

Retarder.Question 14: If registration numbers are to be applied to an aircraft with a letter height of 12 inches, what is the minimum space required for the registration mark N1683C?

Answer:

52 inches.Question 15: If masking tape is applied to an aircraft, such as for trim spraying, and is left on for several days and/or exposed to heat, it is likely that the tape will

Answer:

cure to the finish and be very difficult to remove.