PDF Download
FREE AND STUDY GAMES ABOUT AC EXAM QUESTIONS
Actual Qs and Ans Expert-Verified Explanation
This Exam contains:
-Guarantee passing score -45 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation Question 1: the standard unit for measuring the quantity of heat in a substance is
Answer:
the British thermal unit BTU Question 2: when a TEV or a capillary tube is used as a metering device a low refrigerant charge will cause
Answer:
low head pressure Question 3: an inefficient compressor is usually indicated by BLANK head pressure and Blank suction pressure
Answer:
lower the than normal/ higher than normal
Question 4: A liquid to suction heat exchanger is often used to
Answer:
increase liquid sub cooling
Question 5: a compressor that has a broken valve will cause these symptoms
Answer:
high suction pressure and low discharge pressure
Question 6: frost on the suction line indicates
Answer:
that its temperature is below the dew point and below 32 degrees F Question 7: low operating pressures and low system amp draw this could be an indication of
Answer:
A low airflow across the evaporator
Question 8: the movement of heat by direct contact is called
Answer:
conduction
Question 9: can be used for leak detection with all high pressure refrigerants
Answer:
soap bubble solution
Question 10: moisture in a refrigeration system can cause
Answer:
compressor failure
Question 11: heat which causes a change in temperature of a substance is called
Answer:
sensible heat
Question 12: zero psia is
Answer:
a pressure which cannot be further reduced
Question 13: in order to remove as much moisture as possible from a system
Answer:
triple evacuate the system to 500 microns with a deep vacuum pump Question 14: air or other non condensable gasses in a capillary tube air conditioning system will cause these sysmptoms
Answer:
low suction pressure and high discharge pressure Question 15: which of the following symptoms would be indicative of an oil logged condenser
Answer:
high discharge line pressure and low liquid line pressure
Question 16: bubbles in a sight glass could be an indication of
Answer:
refrigerant blend with a high temperature glide Question 17: A customer complains that their air conditioning system is running constantly, but not cooling enough. the suction line is very cold and the compressor is sweating the most likely cause is
Answer:
a restriction of the return air or a dirty evaporator Question 18: heat added to the refrigerant in a vapor state after the evaporation process is called
Answer:
superheat Question 19: no cooling complaint unit to be completely out of refrigerant technician decides to use a trace amout of refrigerant and BLANK in order to pressurize the system
Answer:
an inert gas
Question 20: an overcharge of refrigerant will cause
Answer:
increased head pressure
Question 21: heat added to a substance without a rise in temperature
Answer:
latent heat of vaporization
Question 22: A temperature differential across a filter drier indicates
Answer:
restricted filter drier Question 23: the temperature at which moisture will start to condense from the air is called
Answer:
dew point temperature Question 24: system is started the compressor is noisy and running hot the most probable cause of the noise is
Answer:
low oil in the system Question 25: which of the following is true of a solenoid valve in a pump down system
Answer:
it is located before the metering device
Question 26: a sight glass would normally be located
Answer:
in the liquid line before the metering device
Question 27: water will vaporize at what temperature in a 28 in hg vacuum
Answer:
100 degrees F