PDF Download
FREE AND STUDY GAMES ABOUT BASIC REFRIGERATION
EXAM QUESTIONS
Actual Qs and Ans Expert-Verified Explanation
This Exam contains:
-Guarantee passing score -72 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation
Question 1: Why do we install sight glass in the liquid line?
Answer:
To see moisture, state of change.
Question 2: What do we do to prevent flashing in the liquid line?
Answer:
Sub cooling in condenser.Question 3: Describe the condition when liquid is forced back to the compressor.
Answer:
Flood back (liquid returning to the compressor)
Question 4: describe total heat.
Answer:
latent & sensible = total
Question 5: What will cause the release of refrigerant from the oil/refrigerant mixture?
Answer:
Sudden reduction of pressure at start up.Question 6: Describe the refrigerant when it leaves the metering device of the system.
Answer:
Reducing flash gas
Question 7: describe the heat compression.
Answer:
heat removed by condenser from refrigent Question 8: As 32°F liquid water is heated we witness:
Answer:
Sensible, Latent, Sensible Question 9: When a substance changes state from a liquid to a gas, the spacing of its
molecules:
Answer:
Increase greatly
Question 10: The ozone layer protects the earth from
Answer:
UV
Question 11: what is specific heat
Answer:
heat required per. unit mass to change one degree
Question 12: In the refrigeration cycle, where will we find superheated vapor?
Answer:
Inlet outlet of compressor
Question 13: What components separate the high side from the low side?
Answer:
Compressor, metering device Question 14: What chemical found in the upper stratosphere indicate that the ozone layer is being destroyed
Answer:
Chlorine Monoxide Question 15: What will result from the oxidation of the lube oil due to overheating?
Answer:
Sludge
Question 16: Describe where the latent heat of condensation is removed.
Answer:
Condenser.
Question 17: What will prevent the compressor from starting?
Answer:
low refrigerant level will not cause L/P switch to acturate
Question 18: What type of refrigerant is R-12
Answer:
CFC Question 19: List several good thermal insulator & therefore poor conductor?
Answer:
Polystyrene = poor conductor Copper, Aluminum = good thermal insulator Question 20: Your electric temp probe shows that the temp of the refrigerant in an evaporator is
40°F. It's condition is:
Answer:
Need the pressure to determine refrigerant condition
Question 21: Where does the refrigerant absorb the latent heat of vaporation?
Answer:
Evaporator.
Question 22: What causes crankcase oil to foam?
Answer:
Refrigerant boiling out of solution with the oil Question 23: discuss the procedure for a burn victim in the vicinity of energized electrical equipment
Answer:
secure power, check vitals, provide comfort
Question 24: Describe the shell on a chiller
Answer:
Casing that encloses the evaporator & condenser Question 25: List the four basic categories for the use of mechanical refrigeration
Answer:
Comfort, Refrigeration, Process, Cryogenics (low temp work) Question 26: Define the refrigeration system between the expansion value & the compressor.
Answer:
Low side
Question 27: What will cause the suction line temperature to increase?
Answer:
Heat load increase
Question 28: When does an automatic compressor restart?
Answer:
Suction pressure increases.