FREE AND STUDY GAMES ABOUT BOILER STUDY GUIDE

PDF Download

FREE AND STUDY GAMES ABOUT BOILER STUDY GUIDE

EXAM QUESTIONS

Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -142 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation

Question 1: how is a plate dog used

Answer:

it buffers to align vertical plates at the weld

Question 2: a pressure differential hydro test on an exchanger is one

Answer:

that is different when fire water is used on the shell and a hydro pump is used on the tubes

Question 3: what is the primary reason for high-point vents in hydrotesting

Answer:

to purge air pockets Question 4: a boiler maker is hydro testing an exchanger and finds that a tube is leaking, what should the boiler maker use to stop the leak

Answer:

plugs

Question 5: a cylindrical tank is 10 ft high and 7 ft in diameter, what is the approximate volume of the tank

Answer:

385.0 cubic feet

Question 6: what is the most commonly used fasteners in boiler construction

Answer:

threaded

Question 7: how many people can tie-off to a vertical lifeline

Answer:

a maximum of two people

Question 8: the best source for information about welding on a tube is the

Answer:

QA/QC

Question 9: which gas passes through the center in a cutting torch tip

Answer:

oxygen Question 10: what is indicated by the notation "3-inch, 150#" on a isometric drawing

Answer:

3-inch diameter, 150# flange

Question 11: which of the following connecting units are used on pipe hangers

Answer:

eye bolts, turnbuckels, threaded rods Question 12: dimensional measurements can be found on all of the following except

Answer:

mechanical flow diagram

Question 13: what is the first thing a boler maker should do before cutting into a tank or vessel

Answer:

determine the content Question 14: on site who determines what grade of material to be used for repair

Answer:

QA/AC

Question 15: what are the four major components of a gate valve

Answer:

body, bonnet, gate, and steam Question 16: when an exchanger tube is plugged, whey is the tube cut before the second plug is installed

Answer:

to prevent pressure build up

Question 17: How should bolts on an 8-bolt flange be tightened

Answer:

in a cross-over pattern

Question 18: where is the exchanger blinded during a tubeside pressure test

Answer:

on the channel head flanges

Question 19: what is a spud wrench most commonly used for

Answer:

aligning flanges Question 20: what type of valve is used on a hydro test tee to maintain test pressure after the hydro has reached its required pressure

Answer:

check

Question 21: a big control valve is pulled. who is responsible for the rigging

Answer:

crane operator and rigger

Question 22: what is one way to permanently support a pipe in a pipe rack

Answer:

with shoes

Question 23: why are there ball checks on sight glass valves

Answer:

to stop the flow if there are leaks or if the sight glass breaks Question 24: what should be done before furnace fittings for tube replacements are ground

Answer:

the inside of the fitting should be inspected

Question 25: what is the most commonly used light lifting device

Answer:

chain hoist Question 26: what type of steel beams are attached to the furnace wall with clips to contain a boilers horizontal expansion

Answer:

buckstays Question 27: a boiler maker who is hydrotaticaly testing an exchanger should have which of the following information

Answer:

the correct test pressure

Question 28: which of the following fasteners is used on concrete

Answer:

expansion anchor bolt