FREE AND STUDY GAMES ABOUT FINAL REVIEW 2201

PDF Download

FREE AND STUDY GAMES ABOUT FINAL REVIEW 2201

EXAM QUESTIONS

Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -71 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation

Question 1: Horsepower in the cylinders

Answer:

indicated

Question 2: Before starting a radial engine, what should be attempted?

Answer:

Rotate the prop in the same direction Question 3: When would small induction system air leaks have the most noticeable effects

Answer:

At low RPM

Question 4: What is grounded when the ignition switch it turned off?

Answer:

P-leads

Question 5: When is the combustion process completed?

Answer:

Shortly after TDC on the power stroke

Question 6: Excessive valve clearance causes the duration

Answer:

to increase

Question 7: Operating valve clearance

Answer:

will be greater when hot

Question 8: What is a choke or tapered ground cylinder

Answer:

• slightly smaller at the top of the cylinder and expands when it heats up. Provides a straight cylinder

bore at operating temperatures

Question 9: Back suction mixture control operates by

Answer:

varying the pressure acting on the fuel in the float chamber

Question 10: What is the purpose of using an impulse coupling with a magneto?

Answer:

To produce a momentary high rotational speed of the magneto Question 11: Why does the smoothness of operation of an engine increase with a greater number of cylinders?

Answer:

The power impulses are closer together

Question 12: What does valve overlap promote?

Answer:

Better scavenging and cooling characteristics

Question 13: Which of the following has the greatest effect on the viscosity of lubricating oil?

Answer:

Temperature Question 14: Grinding the valves of a reciprocating engine to a feather edge is likely to result in -

Answer:

preignition and burned valves

Question 15: Which fuel/air mixture will burn all of the fuel and air?

Answer:

Stoichiometric

Question 16: How many springs are required for valves?

Answer:

2- Redundancy and reduction of vibration, valve flutter dampening Question 17: A condition that occurs in radial engines but not horizontally opposed engines is

Answer:

hydraulic lock Question 18: Which of the following is most likely to occur if an overhead valve engine is operated with inadequate valve clearances?

Answer:

The valves will not seat positively during start and engine warmup

Question 19: E-gap angle is defined as

Answer:

several degrees of magnet rotation beyond the magnet's neutral position

Question 20: What do full floating piston heads allow motion between?

Answer:

the piston and the connecting rod

Question 21: What stroke does the fuel injection system inject fuel?

Answer:

all of them

Question 22: Which would make a good thrust bearing?

Answer:

Deep grooved ball bearing

Question 23: Primary concern when establishing a firing order?

Answer:

• provide for balance and eliminate vibration to the greatest extent possible

Question 24: What are pole shoes made of?

Answer:

laminated soft iron to dissipate magnetism readily

Question 25: Cast iron piston rings may be used in

Answer:

chrome plated cylinders.

Question 26: Which one has the least rolling friction?

Answer:

Ball bearing

Question 27: What are factors that decrease VE?

Answer:

Improper valve timing, sharp bends in the induction system, and high carburetor air temperatures Question 28: Which of the following conditions will lead to bleeding detonation?

Answer:

Low octane fuel