FREE AND STUDY GAMES ABOUT SPECIAL BOILERS MN

PDF Download

FREE AND STUDY GAMES ABOUT SPECIAL BOILERS MN

EXAM QUESTIONS

Actual Qs and Ans Expert-Verified Explanation

This Exam contains:

-Guarantee passing score -120 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation Question 1: After repair work is done on the boiler, what test is done to check for leaks:

Answer:

Hydrostatic test Question 2: On a steam or hot water boiler, the safety valve or safety relief valve could be tested by?

Answer:

By lifting the lever on the valve or raising the pressure until they operate.

Question 3: An indication of soot build-up on a firetube boiler is

Answer:

High stack temperature Question 4: The bottom blow down line on a steam boiler system is located at the:

Answer:

lowest point of the waterside of a steam boiler

Question 5: When hydrostatic test of a boiler exceeds the maximum allowable working pressure

each safety valve, if left attached to the boiler should:

Answer:

Have its valve disc held to its seat by means of testing clamp or "gag" Question 6: The popping pressure of a safety relief valve on a low pressure hot water heating

boiler cannot exceed:

Answer:

160 psi Question 7: A _____ valve is a valve that permits fluid flow in only one direction and closes automatically to prevent backflow.

Answer:

check

Question 8: Why is a pigtail or siphon required in steam pressure gauge lines?

Answer:

To protect the gauge from high temperature

Question 9: When used, a quick opening blowdown valve must be located _____.

Answer:

Nearest to the boiler Question 10: Rules governing the construction of power boilers are set out in ____.

Answer:

ASME Code Section 1

Question 11: The LWCO should be tested how often?

Answer:

Daily Question 12: In a natural draft furnace, the amount of draft is affected by the ________.

Answer:

height of the stack

Question 13: The low water fuel cutoff is tested by blowing down its float chamber or doing what kind of test?

Answer:

An evaporation test.Question 14: The shift engineer of a high pressure boiler plant of over 200 HP must stay within ________of the boiler room at all times during the shift?

Answer:

500 ft Question 15: The shift engineer of a high pressure boiler plant of over 200 HP must stay within _______ of the boiler room at all times during the shift.

Answer:

500 ft Question 16: The ASME Code states that boilers with over ______ square feet of heating surface must have 2 or more safety valves?

Answer:

500

Question 17: When a safety valve opens and closes rapidly it is rendered to as

Answer:

Chattering Question 18: In accordance with the statutes of the State of Minnesota, each electric boiler horsepower is equal to _______kilowatts?

Answer:

10 Question 19: Boiler operation data commonly recorded in a boiler room logbook includes what information?

Answer:

When boiler checks were made, who made the boiler checks, and what specific checks were made.

Question 20: With regard to steam boilers, the letter "HRT" mean _____.

Answer:

horizontal return tubular

Question 21: A high pressure boiler of 25 HP should be checked how often?

Answer:

24 hours

Question 22: What should be posted in the boiler room?

Answer:

Boiler licenses Inspection certificate or exemption certificate Question 23: Can a low water condition occur in a hot water heating type boiler?

Answer:

Yes, for numerous reasons Question 24: In most US jurisdictions, and _______boiler inspection is mandated by law?

Answer:

Annual

Question 25: Expansion bends or joints are installed in piping systems to_____.

Answer:

allow for expansion and contraction of the piping without causing damage

Question 26: How many ways can heat be transferred

Answer:

3 Question 27: Continuous blowdown systems are used in boilers to help control the ______

________ ________.

Answer:

dissolved solids concentration