PDF Download
FREE AVIATION AND STUDY GAMES ABOUT AET(NCATT)
EXAM QUESTIONS
Actual Qs and Ans Expert-Verified Explanation
This Exam contains:
-Guarantee passing score -219 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation
Question 1: where is the outer shield of a coax cable grouded at
Answer:
at the source or input edge
Question 2: what are some causes of ESD
Answer:
dry conditions(0-20 humidity rate) or poor boding
Question 3: what type of wave form is produced by a sinusoidal oscillator
Answer:
sine wave
Question 4: what type of transistor is T1
Answer:
N-channel JFET
Question 5: what type of amplifier coupling is used for impedance matching and circuit isolation
Answer:
transformer Question 6: the thermocouple transducer will increase its output voltage when the heat is
Answer:
increased Question 7: what is the resistance and tolerance of resistor value yellow-blk-wh-gold
Answer:
40 G ohms +/-5%
Question 8: what do trim tabs do
Answer:
work with flight controls to reduce the workload on the pilot(balance the forced across control surfaces)
Question 9: what percent is Collector current
Answer:
95%
Question 10: describe a full subtractor
Answer:
there is a borrow applied to the input
Question 11: ESD is negligible provided what
Answer:
that all electrical structural are properly bonded or grounded Question 12: when removing an ESDS circuit card from a transmitter the electronic technician must
Answer:
be at the same potential as the transmiter
Question 13: who is responsible for providing an msds with chemicals
Answer:
chemical manufacturer
Question 14: what type of transistor is T6
Answer:
P-channel Enhancement-mode MOSFET
Question 15: how do you prevent ESD
Answer:
grounding hand tools work bench and body(wrist straps) Question 16: what happens to current in a Zener diode if voltage in the reverse bias directions is increased
Answer:
increase (it will decrease if the voltage increase is in the forward bias direction)
Question 17: what is the purpose of a capacitor
Answer:
Store electrical energy
Question 18: what mode is the referenced Op Amp operating in
Answer:
inverting mode
Question 19: what is kirchhoffs voltage law
Answer:
the sum of the voltage drop across the resistors must be equal the voltage applied
Question 20: when is hysteresis loss the greatest
Answer:
at high frequency
Question 21: why is stainless steel safety wire used with steel bolts
Answer:
prevent dissimilar metal corrosion
Question 22: what would the voltage be in the secondary winding
Answer:
0Volts
Question 23: Resistor color band grey is
Answer:
8 Question 24: how many time constants does it take for a capacitor to be approximately 100% fully charged
Answer:
- times constants
Question 25: if the forward bias is increased in a NPN transistor the resistance will
Answer:
decrease Question 26: when testing a diode, infinite resistance is measured in both direction. what is the problem
Answer:
the diode is open
Question 27: Resistor color band red is
Answer:
2 Question 28: what is the resistance of normally closed contacts when the relay is de-energized
Answer:
0-ohms/short