PDF Download
FREE COMPUTERS AND STUDY GAMES ABOUT CISCO
EXAM QUESTIONS
Actual Qs and Ans Expert-Verified Explanation
This Exam contains:
-Guarantee passing score -118 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation
Question 1: Frame Relay relays packets at which layer of th e OSI model?
Answer:
2
Question 2: What are 3 components of a LAN conenction?
Answer:
Router, hub, switch Question 3: What happens if you change the configuration register to 0x2142 then reset the router?
Answer:
Router will boot from Flash memory without loading the startup config
Question 4: Ethernet Wires
Answer:
1,2,3,6
Question 5: How many frames can pass through a 24 port switch simultaneously, without causing a colision and with full duplex used on all ports?
Answer:
24 Question 6: What is a layer of the OSI model, but not the TCP/IP protocol stack?
Answer:
presentation layer Question 7: How many frames can pass through a 24 port hub simultaneously, without causing a collision?
Answer:
1 Question 8: What network module must be installed to make a Catalyst 6500 series switch function?
Answer:
Supervisor Engine module Question 9: Which port types can be used in large chassis Switch ethernet modules?
Answer:
GBIC, SFP, RJ45
Question 10: What can be used to separate networks by breaking the network into multiple LAN segments called IP subnets?
Answer:
Router
Question 11: What problem would cause fa 0/0 is up, line protocol is down?
Answer:
encapsulation type mismatch
Question 12: RIP and OSPF are what type of protocols?
Answer:
Routing
Question 13: What information does the "show interface" command display?
Answer:
encapsulation type, layer 2&3 address Question 14: What is the command to enter priviledged EXEC mode from user EXEC mode?
Answer:
enable
Question 15: What is the default value of the configuration register?
Answer:
0x2102 Question 16: What approach eliminates loops when multiple switches are implemented in a network?
Answer:
spanning tree protocol Question 17: How many twisted pairs of wire are typically used in a leased line between two routers?
Answer:
- pair
Question 18: Global Configuration Mode
Answer:
Router(config)#
Question 19: What can provide diagnostic functions such as loopback testing?
Answer:
CSU/DSU
Question 20: What is the port speed when the color of the port speed LED is solid green?
Answer:
100 Mbps
Question 21: Privileged EXEC mode
Answer:
Router# Question 22: Which command can be used to diagnose a network connectivity problem?
Answer:
Ping Question 23: What is the command to enter privilege EXEC mode from the user EXEC mode?
Answer:
enable
Question 24: What is unicast traffic?
Answer:
data traffic that is sent to one device
Question 25: What type of cable is used from a Switch to a Hub?
Answer:
RJ45 crossover
Question 26: Which IOS commands merge the saved configuration to the running
configuration?
Answer:
copy tftp run, copy start run Question 27: Transmits bits from 1 computer to another. Defines how cable is attached to the network and what transmission technique is used
Answer:
OSI Level 1 - Physical Question 28: What separates the service providers equipment from the customer's wiring and equipment?
Answer:
demarcation point