MODULE 5 - INTRODUCTION TO PLUMBING DRAWINGS

PDF Download

MODULE 5 - INTRODUCTION TO PLUMBING DRAWINGS

EXAM QUESTIONS

Actual Qs and Ans - Expert-Verified Explanation -Guaranteed passing score -33 Questions and Answers

-Format: Multiple-choice / Flashcard

Question 1: the _______ is the minimum distance that must be maintained between a structure and the structures property line, such as a Street

Answer:

Setback Question 2: The location of the sewer and water mains and the location of the building on the property is shown on the______

Answer:

Plot plan Question 3: The reasons that codes may set a minimum width for _______Including providing access to rear yards and reducing the possibility of a fire jumping from one building to another

Answer:

Side yards Question 4: _______ Are marks or drawings that represent specific objects are materials

Answer:

Symbols

Question 5: The layout of the rooms in a building is shown on the _______

Answer:

Floor plan Question 6: ________ show the location of the outlets, switches, and electrical fixtures in a structure

Answer:

Electrical drawing Question 7: Vertical and horizontal piping along with sizes and a riser number that refers back to the full set of plumbing drawings are shown on

Answer:

Riser diagrams Question 8: To ensure that there are no conflicts with the furnace and air conditioning equipment, refer to the _______

Answer:

HVAC/mechanical drawing

Question 9: I drawing with dark reddish lines is called a

Answer:

Sepia Question 10: The term blueprint is used interchangeably with ________ it originally referred to drawings that appeared as white line drawings on a solid blue background

Answer:

Construction drawings Question 11: If an object is depicted from one or more of six possible angles, the illustration is a

_______

Answer:

Orthographic drawing

Question 12: To check for certain practices that must be used in installing and testing a plumbing system, a plumber refers to the________

Answer:

Specifications

Question 13: Limited space may require you to use ________

To indicate the limits of a dimension on a drawing away from the actual points of the dimension

Answer:

Extension lines Question 14: A representation of an object that gives the impression of three dimensions resembling the physical object is called _______

Answer:

Isometric Question 15: Drawings of products that provide enough detail to show how the product is constructed are called _______

Answer:

Cutaway drawings Question 16: Sections of the main drawing that are enlarged to show important structural elements more clearly are called ________

Answer:

Details Question 17: To identify where floor drains and DWV pipes may be installed beneath the basement floor, refer to the _______

Answer:

Foundation plan Question 18: ________ Show the vertical elements of the building, such as the height and width of interior or exterior walls

Answer:

Elevation drawings

Question 19: _______ are lines with arrows or slashes at a termination line used to indicate the dimension of a distance on a drawing

Answer:

Dimension lines Question 20: Compared to the requirements specified in applicable codes, it is acceptable for the plans and specifications for a particular building to call for an installation that is of_______

Answer:

Higher quality Question 21: A _______, also called ________ Provides information about where are you may not build on certain parts of the property

Answer:

Plot plan, site plan

Question 22: To establish the limits of a measurement on the drawing use

Answer:

Extension lines Question 23: After the architect or engineer approved the fixture or fitting in a catalog drawing, it becomes

Answer:

Approved submittal data Question 24: The act of showing the actual building, room, or object reduced in proportion from full-size to a smaller size is called

Answer:

Scaling the drawing Question 25: ________ shows the piping system with the location of fixtures in pipe runs and the size and type of pipe to be installed

Answer:

Plumbing drawing