NACE CIP 1 CBT EXAM PRACTICE QUESTIONS AND ANSWERS ALREADY GRADED A+

NACE CIP 1 CBT EXAM PRACTICE QUESTIONS AND ANSWERS ALREADY GRADED A+

NACE CIP 1 CBT EXAM PRACTICE

QUESTIONS AND ANSWERS

Dew point is the temperature at which

Correct answer- condensation occurs.

You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank

lining is being applied. After application of the 19 coat you notice small blisters in some

areas of the applied lining. Your FIRST preferred course of action is to:

Correct answer- Document the problem and advise the Contractor and Owner's

representative.

If a contractor is using a poorly maintained compressor to supply air for abrasive blast

cleaning and conventional airspray, the coating inspector should perform a

Correct answer- blotter test for the presence of oil and water.

Upon arrival of coating materials, the inspector should

Correct answer- observe and document the amount of material and batch numbers.

Relative humidity is

Correct answer- a measure of the amount of moisture in the air compared to saturation

level.

Galvanic corrosion occurs on which of the following substrates?

Correct answer- Metal

When applying Thermal Spray Coatings the specification is most likely to reference:

Correct answer- SSPC-CS 23.00/AWS C2.23/NACE No. 12

What is the minimum recommended distance away from an edge that an inspector

should take a measurement with a dial type magnetic pull off Dry Film Thickness(DFT)

gauge?

Correct answer- 2.5 cm (1 inch)

Polymerization is the process of?

Correct answer- Monomers joining together.

An exposed area of the substrate or previous coat of a conductive material, often

caused by poor application technique is called:

Correct answer- Holiday

Checking is:

Correct answer- a fine crack in the surface of a coating that rarely reaches the

substrate.

Inspection documentation is important because:

Correct answer- Owners use the documentation for a variety of purposes.

An Inspectors personal log book should contain:

Correct answer- No comments regarding the application team.

You have just received your NACE CIP Level 1 certification when you are asked to

supervise a team of uncertified field pipeline inspectors. Your FIRST preferred course of

action is to:

Correct answer- Review the NACE Attestation prior to making a decision.

Good record can provide maintenance departments with detailed information about ALL

of the following EXCEPT:

Correct answer- How the item was coated.

Non Conformance Reports are completed by the Inspector:

Correct answer- When the Inspector and Contractor deem it to be significant non

conforming item.

The initial steel condition is important to the NACE Inspector because:

Correct answer- The Inspector may have to reject the steel.

The form of corrosion that has the largest potential for unexpected catastrophic failure

is:

Correct answer- Galvanic Corrosion

What is used to determine compressed air cleanliness?

Correct answer- Profilometer

Osmotic blistering is most likely to occur as a result of:

Correct answer- Airless spray application.

When performing tests for oil and grease using an ultra violet light, the NACE Inspector

should be aware that:

Correct answer- Synthetic oil or grease may not be identified.

To achieve consistently accurate results with ALL alt test equipment:

Correct answer- wash your hands before sampling.

When holiday testing is required the Inspector is always required to enforce what

standard?

Correct answer- NACE SP 0188