NACE CIP 1 CBT EXAM AND ANSWERS COMPLETED 2026 Complete And Study material 21pages LEARNEXAMS

Dew point is the temperature at which - answercondensation occurs. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of action is to: - answerDocument the problem and advise the Contractor and Owner's representative. If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a - answerblotter test for the presence of oil and water. Upon arrival of coating materials, the inspector should - answerobserve and document the amount of material and batch numbers. Relative humidity is - answera measure of the amount of moisture in the air compared to saturation level. Galvanic corrosion occurs on which of the following substrates? - answerMetal When applying Thermal Spray Coatings the specification is most likely to reference: - answerSSPCCS 23.00/AWS C2.23/NACE No. 12 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial type magnetic pull of Dry Film Thickness(DFT) gauge? - answer2.5 cm (1 inch) Polymerization is the process of? - answerMonomers joining together. An exposed area of the substrate or previous coat of a conductive material, often caused by poor application technique is called: - answerHoliday Checking is: - answera fine crack in the surface of a coating that rarely reaches the substrate.