.png){kind=logo}
PDF Download
TEC GENERAL SAFETY AND SECURITY ORIENTATION TEST
Actual Qs and Ans Expert-Verified Explanation
This Exam contains:
-Guarantee passing score -24 Questions and Answers -format set of multiple-choice -Expert-Verified Explanation Question 1: TEC facilities require fall protection with the fall exposure is _____ feet or more
Answer:
Fill out a confined space permit Conduct a RISK assessment briefing with the TEC project supervisor prior to entry Make no entry into any confined space until TEC has reviewed the permit and given approval
Question 2: Only in designated areas
Answer:
Smoking, including the use of electronics cigarettes, is allowed
Question 3: Which does not apply to equipment and to use
Answer:
Cut towards yourself
Question 4: Extension in straight ladder requirements are
Answer:
True
Question 5: True
Answer:
All contractors so have plans to account for their personnel after an incident
Question 6: Chemicals
High voltage High heat work environments
Answer:
Which is a hazard that may be found on a TEC site Question 7: Where exposed blades must be used, which is an example of precautions that shall not be takin
Answer:
A tie off at the top Someone to foot the ladder Question 8: Contractor personnel are not required to be trained and qualified to operate the equipment they utilize
Answer:
50
Question 9: Process Area
Answer:
Any area where equipment or systems may be operational in the support of megawatt production and/or transmission and distribution
Question 10: Minimum PPE requirements while on site include
Answer:
Dark lens in low light areas
Question 11: True
Answer:
If a contractors safety program conflicts with TEC program(s), the contractor shall notify TEC for direction regarding resolution
Question 12: What must be done prior to any hot work activities
Answer:
- hour
Question 13: Spill prevention and control and countermeasures plans (SPCC) are written documents that describe the steps a facility must take to prevent oil spills and to minimize risk of harm to surface waters in the event of a release or oil spill
Answer:
It is critical to safety and to the environment Question 14: _____ Is indicated by a "red" tag and only personnel assigned to work in the area and who receives a job briefing to address the hazards may answer that area
Answer:
Hard hat/Safety glasses with side shields Question 15: Electrical equipment greater than blank volts shall be de-energized and hazardous energy control (HEC) applied before work begins
Answer:
Can be taken home and used when removed from service
Question 16: Why is good housekeeping important
Answer:
Have a valid drivers license to operate a motor vehicle on site Adhere to safe work practices and policies Successfully complete the safety orientation Always have a badge on your person while on site
Question 17: When entering a confined space, contractor shall
Answer:
Section "A" and/or "B" of TEC hot work permits shall be completed Hot work permits shall be approved by designated TEC personnel Follow procedures to prevent accidental fire Remove all flammables and combustibles within a 35' radius
Question 18: Before operating cranes and rigging
Answer:
False
Question 19: Approved eye protection includes all of the following except
Answer:
4 Question 20: A dedicated firewatch is to be provided during the entire hot work operation and for a minimum of _____ after hot work is completed or interrupted
Answer:
TEC must be notified of the intent to bring, use or store any chemicals on site Safety data sheets (SDS) must be available to personnel on site Containers must be labeled Chemicals must be approved by TEC prior to bring on site
Question 21: Hazards associated with the job
Barriers put in place Work procedures involved PPE requirements
Answer:
25
Question 22: Be identified with company name
Use designated entrance gates Park in the designated Parking Areas (all of the above)
Answer:
Contractor vehicles shall Question 23: All barriers in barricades so I'll be tagged every _____ feet on all sides
Answer:
Danger
.png)