TTT1 Exam Questions And Answers 100% Pass

TTT1 Exam Questions And Answers 100% Pass
Who is the third party group that approves and endorses standards?
American National Standards Institute
What term is used to describe the documents written by members, or peers, in the
industry?
Standards
A company's health, safety and environment policy should be a combination of labor
regulations and ?
Industry standards
Where OSHA has not promulgated specific standards, who is responsible for following
the acts general clause?
Employer
On a job site who should be involved in the JHA process?
The Whole Crew
What does the Term SOW stand for?
Scope Of Work
The letters JHA stand for what ?
Job Hazard Assessment
When using a extension ladder, how many feet past the platform must it extend?
3
If you have a sixteen foot ladder leaning against a building wall, how many feet from the
wall does the case need to by to have the correct slope?
4
Work boots with ankle support are recommended for all work sites?
True
What do the letters PPE stand for ?
Personal Protective Equipment
What does the ground fault circuit interrupter (GFCI) do?
Senses a short circuit, prevents electrocution , shuts off the flow of electricity
Who is responsible for providing PPE?
Employer
When using a y-lanyard attached to your back d-ring, at what height should the
connection to your anchorage be placed?extend?
Shoulder level or above
What is the maximum distance between the sternal d-ring and the fixed safety climb?
Nine inches
When calculating a fall distance using a "6 foot" energy absorbed, what is the maximum
pull out distance?
Four feey
What is the minimum force that a work positioning system anchorage must be able to
withstand?
Two times the arresting force of 3000lbs
What minimum force must a non-engineered anchor be able to withstand for fall
protection use?
5,000 lbs
When working, how often should fall protection equipment be inspected ?
Daily before each use
According to the applicable industry standard, what is the minimum height from a lower
surface or ground where fall protection must be used?
Six feet
How many pounds force is one kilo Newton(kN)
225
What are the four most common types of towers used to support telecommunications
antennas?
Guyed towers, self-support towers, monopoles, and non- standard
What identifies a self-support tower?
Horizontal member
What is not a component on a guyed tower?
Gin pole
What is the purpose of a turnbuckle when working with guy wires?
Adjusts the tension
Which government organization regulates tower lighting ?
FAA
When completing tower demolition, what must you have in place before you start the
job?
Demolition permit
When completing the visual inspection of a foundation, what is one of the key items to
look for?
Cracks
What term identifies a monopole component?
Base flange
According to the manufacturers specifications, what is the minimum number of ground
kits installed on a single Run?
Three
What type of antenna is used to transmit signal from tower to tower?
Microwave dish
Where should a coax ground be placed vertically in relation to the hoisting grip?
Above it
When using tape and butyl to weatherproof a ground kit, what is a critical step in this
process ?
Cut the tape when terminator
When inspecting a wire rope diameter the actual diameter is slightly larger then the
specific diameter ?
True
What does FS stand for in rigging applications ?
Factor or safety
The outer sheath of synthetic endless sling is part of the slings strength?
False

TTT1 Exam,TTT1 Test,TTT1 Flashcard,TTT1 quiz,TTT1 Practice,TTT1 Practice test,TTT1 Practice flashcard,TTT1 Practice exam,TTT1 Study guide,TTT1 Practice questions,TTT1 Questions,TTT1 Practice questions and answers,TTT1 Questions and answers,TTT1 pdf,TTT1 quizlet,TTT1 reddit,TTT1 Answer sheet,TTT1 Answer key,TTT1 Pdf free,TTT1 Exam help,TTT1 Cheat sheet,TTT1 quiz bank,TTT1 Questions bank,TTT1 Practice Guide,TTT1 Guide,TTT1 Testbank,TTT1 Practice Answers,TTT1 Answers,TTT1 Exam prep,TTT1 Prep,TTT1 Pdf download,TTT1 Flashcards,TTT1 Real questions,TTT1 Actual questions,TTT1 Real Questions and answers,TTT1 Actual Questions and answers,TTT1 Exam review,TTT1 Review,TTT1 Exam questions,TTT1 Exam questions and answers,TTT1 Practice test pdf,TTT1 Practice test quizlet,TTT1 Practice test Reddit,TTT1 Practice test quizlet multiple choice,TTT1 Exam study guide,TTT1 Practice test free,TTT1 Test questions,TTT1 Exam study guide,TTT1 Practice exam free,TTT1 Practice tests free,TTT1 Exam practice test,TTT1 Exam test questions,TTT1 Exam questions and answers,TTT1 Exam practice test