Actual Exam Questions with Correct Verified

pg. 1 NCCCO Overhead Crane New Update Actual Exam Questions with Correct Verified Answers/ Graded A+

On a lattice boom crawler crane, the main boom length is measured from the: - Correct Answer - Center of the boom heel pins to the center of the boom tip sheave

What is the main purpose of mid point suspension pendants? - Correct Answer - To absorb shock that comes with dynamic loading

The main purpose of a gantry or a mast on a crane is: - Correct Answer - To increase the crane's leverage on the boom

What effect does having the crawlers retracted have on a crawler crane with a long boom - Correct Answer - Increases the probability of tipping

When using a mobile crane on a barge, the crane's load capacity chart shall be - Correct Answer - Replaced by a list chart

Blocking can be placed under the ends of tracks to: - Correct Answer - Increase the crane's stability when operating over the front or back

Overhead cranes with more than one hoisting unit shall have? - Correct Answer - Its rated load marked on it.

How often does O.S.H.A. require a written wire rope inspection? - Correct Answer - Once a month

• / 3

pg. 2 What is the purpose of the "E" (Emergency) stop on an overhead crane? - Correct Answer - Removes power to entire crane.

Most loads should be rigged to within how many degrees of level? - Correct Answer - 5

According to ASME B30.2, what is the safety factor for rigging? - Correct Answer - 5 to 1

According to O.S.H.A. frequent inspections shall be performed? - Correct Answer - Daily to monthly

According to ASME B30.2 a frequent inspection must be performed by a? - Correct Answer - Designated person

According to OSHA, the maximum twist of the hook can't exceed? - Correct Answer - 10 degrees

When inspecting electrical contacts, what are the signs they are bad? - Correct Answer

• Pitted or burned

According to ASME B30.2, what type of fire extinguisher is required for overhead cranes? - Correct Answer - 10BC

Before leaving an overhead crane unattended, attached loads should be? - Correct Answer - Lowered to the floor

Before using your hand to steady any load, you should? - Correct Answer - Follow company policy

According to OSHA, the rated capacity of all overhead cranes shall be? - Correct Answer - Clearly marked on the side of the crane

• / 3

pg. 3 When attaching spreaders to any load, you must keep in mind that? - Correct Answer - The lower the spreader angle the greater the tension

By order of hitch strength, which is correct?

• Vertical, basket, choker
• Basket, vertical, choker
• Basket, choker, vertical
• Choker, basket, vertical - Correct Answer - Basket, vertical, choker

According to OSHA, the maximum hook throat opening must not exceed? - Correct Answer - 15% of its original size

How many cubic feet is in a rectangular object that measures S At. X3 At. X2 ft.? - Correct Answer - 30 cubic feet

An object weighs 150 lbs per cubic foot and measures 4 ft. X3 A. X3 ft., what is its weight? - Correct Answer - 5,400 lbs

According to OSHA, how many wraps must be left on the hoist drum of an overhead crane with the hook at its lowest position? - Correct Answer - 2 wraps

The upper limit switch of all overhead cranes shall be tested every? - Correct Answer - Shift

Vertical movement of an overhead crane is controlled by the? - Correct Answer - Hoist controller

A swinging load should be controlled by the? - Correct Answer - Bridge and trolley controller

• / 3