ADVANCED RIGGING NEWEST ACTUAL UPDATED

ADVANCED RIGGING NEWEST ACTUAL / UPDATED

TEST QUESTIONS AND 100% CORRECT ANSWERS

VERIFIED/GRADED +

34) A document that outlines weights, crane configuration and

rigging requirements for a lift is called a: - ----Answers---Lift

plan

35) A 1-inch wire rope sling in vertical basket hitch lifting a 24- foot long, 36 inch diameter pipe, - ----Answers---36 to 1

36) What is an LMI? - ----Answers---Load movement indicator

37) Location of electrical hazards on the job site should be

documented on a: - ----Answers---Lift plan

38) When forming a lift plan, a PRIMARY concern for the

person doing the rigging is: - ----Answers---Capacity of

rigging

39) When using a wedge socket, the dead end of the rope is

secured in the socket by the: - ----Answers---Wedge

• / 2

40) When erecting or stowing a swing-away lattice extension, what should be used to control the movement of the extension? - ----Answers---Tag line

41) Planning for rigging is required: - ----Answers---Only

when lifting any load

42) A lift plan MUST be completed by a: - ----Answers---

Supervisor

43) Anchorage points for fall arrest harness for a single

person MUST be able to hold: - ----Answers---5000 lbs.

44) Which of the following items are used for heavy rigging? - ----Answers---Slings, shackles, and spreader beam

45) If the jacket of a synthetic round sling is damaged, that

sling should be: - ----Answers---Removed from service

immediately

46) Which of the following is NOT a factor when making submerged lifts? - ----Answers---Water temperature

47) When a tugger is mounted where the operator can NOT see the load, the signal person most uses - ----Answers--- Signals used for cranes

• / 2