Michigan DMV CDL Test Questions With

Michigan DMV CDL Test Questions With Correct Answers    What does "axle weight" mean? - CORRECT ANSWER✔✔-The Weight transmitted between the ground by one axle or one set of axles What statements are true about backing? (Both) - CORRECT ANSWER✔✔--Backing is always Dangerous

• you should back and turn to the drivers side whenever possible

Inspect your cargo after you have driven - CORRECT ANSWER✔✔-25 miles or 50 miles, Depending on the law in the state you are in. again after 3 hours or 150 miles What is true about tires and hot weather driving? - CORRECT ANSWER✔✔-When driving in very hot weather, You should inspect your tires every two hours or every 100 miles Turn signals should be used - CORRECT ANSWER✔✔-at least 100 feet before turning or changing lanes How to warn drivers of a stopped vehicle? - CORRECT ANSWER✔✔-Move the rear reflective triangle back if the drivers vision is obscured to within 500 feet How can you avoid the effects of wet brakes? - CORRECT ANSWER✔✔--Gently apply the brakes, Increase engine rpm, cross the water while pressing the brakes lightly -Slow down and place the transmission in low gear 1 / 2

You do not have a hazardous materials endorsement on your commercial drivers license. You can drive a vehicle hauling hazardous material when? - CORRECT ANSWER✔✔-The vehicle does not require placards In your pre-trip inspection, you are checking your steering and exhaust systems. Which of these problems should be fixed before the vehicle is driven? - CORRECT ANSWER✔✔-steering play in excess of 10 degrees ( 2 inches on a 20 inch wheel) While you are driving you should use your mirrors to check - CORRECT ANSWER✔✔--The condition of tires and cargo

• where the rear of the vehicle is when making turns

the reaction distance is the distance traveled from the time - CORRECT ANSWER✔✔-the brain tells the foot to push the brake pedal to the time the foot actually pushed the brake pedal What is the minimum length for mud flaps? - CORRECT ANSWER✔✔-Within 8 inches of the surface of the road Whether or not you load and secure your load yourself, You are responsible for? - CORRECT ANSWER✔✔--Recognizing overloads and poorly balanced weight.

• Knowing that your cargo is securely tied down and covered.

When driving through roadway work zones, You should - CORRECT ANSWER✔✔-Watch for sharp pavement drop offs Which of these is NOT caused by rough acceleration - CORRECT ANSWER✔✔-Tire damage What is an "escape ramp?" - CORRECT ANSWER✔✔-ramps that are located a few miles from the top of a downgrade to help you stop

• / 2