NAVFAC P-307 TRAINING NEWEST ACTUAL EXAM

NAVFAC P-307 TRAINING NEWEST ACTUAL / EXAM

QUESTIONS AND ANSWERS.VERIFED/GRADED A+.

when selecting rigging gear for a job, which of the statements below should be followed?never used damaged gear consider height restrictions when selecting sling length never use gear past it's inspection due date base rigging gear on the total stress, not just the weight of the load follow all of the above

What should be used between the rigging gear and the load to prevent damage to the load and rigging?appropriate sling protection

two people can operate a chain fall if the pull chain is too hard for one person to pull while hoisting a load false

pulls outside the plane of the eye are allowed as long as the rated load has been decreased 1 / 3

false

the minimum depth of thread engagement for a 3/4 inch eyebolt into a steel object is

• 1/8 inch

an angular pull of 45 degrees is allowed on non-shoulder type eyebolts false

the rated load of swivel hoist rings must be reduced when they are used for angular pulls.false

What markings are required on hoists?the name of the manufacturer, model number, rated load, and re-inspection due date

What are the two types of inspections performed on hoists and rigging equipment?Pre-use inspection 2 / 3

Periodic Inspection

when securing a chain hoist _______ may be used by securing the hand chain around the load chain.galf-hitches

two people may operate a hoist at the same time if the pull chain is too hard for one person to pull false

A hoist can be hung from a wire rope sling without a shackle installed if the diameter of the hook is equal to greater than the diameter of the sling.true

when lifting a load that is near the rated capacity of the hoist

the hoist brake should be checked by:

lifting the load just clear of its supports, stopping movement, then checking to ensure the load is not lowering

why should hoists not be used in tie down applications?

• / 3