.png){kind=logo}
- / 5
NEIEP 800 Final Exam Questions and Verified Answers 100% Guarantee Score Pass
Consist of 100 Questions and Answers
- When welding a joint, lay inch tack welds degrees apart, shift it
90 degrees and lay two more 1 inch tack welds 180 degrees apart.Ans>> 1, 180
- On power units having the motor beneath the tank, the pump may be either
- The purpose of the / is to silence the effect of any pulsations in the
driven or coupled.Ans>> belt, direct
pump output and should be as close to the pump as possible.Ans>> silencer, muffler
- On Bolsters/Bolster Assembly, the plunger is fastened to the
which is then mounted to the center of the Bolster Assembly. 1 / 3
- / 5
Ans>> platen plate
- With wye-delta, reduced current starting is accomplished without the need for .
Ans>> resistors
- run buttons should run the platform and sling at leveling speeds only.
Ans>> Temporary
- A consists of a piston held closed by an adjustable spring and must
open at a certain pressure to prevent any further increase in pressure.-
Ans>> relief valve
8.A lowering valve allows the car to be lowered at a speed not exceed- ing 20fpm in case of power failure.Ans>> manual
- As the oil temperature changes, the will change as well and will
effect the performance, more specifically, the leveling and approach of the elevator.Ans>> viscosity
- Be sure wellways are properly to avoid accidental injury to you, your
team or anyone working outside of our industry.Ans>> barricaded 2 / 3
- / 5
- Barricades around the wellway must be inches high and be capable of
withstanding a lb force.Ans>> 42, 200
12.A protects you if you come in contact with a hot wire or component and then come in contact with ground. It opens the circuit and diverts the supplied current to ground.Ans>> GFCI
- / 3
.png)