.png){kind=logo}
- | Page
NICET LEVEL 1 EXAM
EXAM WITH CORRECT SOLUTIONS.
- wires - correct answer- what is the maximum number of 14
AWG RHH conductors which can be installed in 1/2 rigid metal conduit?
3.5'-48" to the actuator - correct answer- Which of the following would be an appropriate mounting height for a pull station?
- flash per second - correct answer- What is the minimum flash
rate for a visible notification device?
90" to the top of the device - correct answer- What is the minimum mounting height for audible notification devices?
Such that the entire lens is not less then 80" - correct answer- What is the minimum mounting height for visible notification devices?
- / 3
- | Page
Voltage=Current X Resistence - correct answer- What is the formula for Ohm's Law
Put your meter in series with the circuit - correct answer- When
using your mult-meter to measure, you must:
Semi-annually - correct answer- Waterflow devices shall be tested with that frequency?
Annually - correct answer- With what frequency shall ionization smoke detectors be given a functional test?
24 hours in normal operation, 5 minutes in alarm - correct answer- What are the standby power requirements for a proprietary signaling system?
Shunt type - correct answer- Which of the following is a type of auxiliary protective signaling system?
A UL listed central station A receiver located at an unlisted monitoring facility 2 / 3
- | Page
A fire department or communications center - correct answer- Remote station signaling systems are permitted to send signals
to:
600V - correct answer- Non-power limited fire alarm cable shall
have an insulation rating of:
20,000 CFM HVAC system serving a single floor 15,000 CFM HVAC system serving 3 floors 20,000 CFM HVAC system serving 2 floors - correct answer- Which of these HVAC systems would require duct detectors on supply and return?
Group A, E, F - correct answer- According to the IBC, which of the following use Groups require visual notification?
Every 4 hours - correct answer- Digital Alarm communicator transmitters (DACT) which use call forwarding to the DACR shall be tested with what frequency?
True - correct answer- When connecting 4 wires smoke detectors to a fire alarm system, the power conductors shall be monitored for integrity.
- / 3
.png)