ROOFING PRACTICE EXAMNEWEST ACTUAL TEST 1

ROOFING PRACTICE EXAMNEWEST ACTUAL / TEST 1

WITH QUESTIONS AND ACCURATE ANSWERS GRADED A+

A(n) ______ is a material that is sometimes used in the process of seaming single-ply membranes to prepare the surfaces and increase the shear strength of the field splice. - ---Answers-- -primer

What is the minimum thickness for an aluminum standing seam roof with a 22-3/4" pan width? - ---Answers---.040"

What is the temperature range for Type III asphalt applied with a mop application? - ---Answers---430 degrees F +/- 25 degrees F

When installing the base sheet of a built-up roof system over plywood decking, nail all laps at________ centers. - --- Answers---9"

When installing wood shakes or wood shingles, the units in the starter course should be laid so that the butt ends extend about ______ beyond the finish fascia board. - ---Answers---1- 1/2"

• / 2

According to the Florida Building Code, underlayment shall be

a minimum of ______ layers for roofs with slopes less than 4:12,

and conforming to ASTM D226. - ---Answers---2

After 3 years of installation, a steep-slope Energy Star roof system must have a solar reflection GREATER than or equal to

• ---Answers---0.15 SRI

In the absence of manufacturer's recommendations, which fastener is acceptable for all metal roofs? - ---Answers--- stainless steel

Ladder jack scaffolding shall not exceed _____ feet in height. - ---Answers---20

According to Florida Building Code, when installing skylights on a single family residence, curbs may be omitted if the pitch

of the roof is a minimum of - ---Answers---3:12

According to Florida Building Code, what is the minimum

headlamp for a slate shingle roof with a 6:12 slope - ---

Answers---4"

According to SMACNA, in most cases, downspout size should NOT be less than how many square inches in cross-section? - ---Answers---7 square inches

• / 2