Rope Rescue Ops IFSI Latest Update -

Rope Rescue Ops IFSI Latest Update - Actual Exam from Credible Sources with 165 Questions and Verified Correct Answers Golden Ticket to Guaranteed A+ Verified by Professor

1 in tubular webbing has a tensile strength of approx - CORRECT ANSWER: 4000lbs

8mm & 9mm accessory cord is - CORRECT ANSWER: Covered in the cordage institute rope construction standards

A 15:1 ratio for rope strength use to be a NFPA standard but a more realistic ratio is suggested to be - CORRECT ANSWER: 10:1

A bottom belay will - CORRECT ANSWER: will not arrest a fall if the main line fails.

A class one harness is designed to stop rescuer when he: - CORRECT ANSWER: Reaches the edge

A double overhand knot is also referred to as a - CORRECT ANSWER: barrel knot,

back-up knot, safety knot

A helmet used for repor rescue should be an approved light weight helmet with a: -

CORRECT ANSWER: 3 point strap position under the chin

A knot used to isolate a bad spot in the line in an emergency is a: - CORRECT

ANSWER: lineman's loop

A knot used to join webbing together is referred to as a/an - CORRECT ANSWER:

Water knot, ring-bend knot, Overhand bend knot

• / 3

A knot with a small internal radius bends, as those found in square knots or over hand knots will .... when tied in 1/2 inch kernmantle rope - CORRECT ANSWER: be weaker

A munter can be used as a means of lowering a load 300 lbs or less in an emergency

and also for - CORRECT ANSWER: rappelling

A munter system is designed for loads less than - CORRECT ANSWER: 300 lb

A type of knot construction used to join two ends of the webbing together and at the

same time create a loop in the end of the webbing is called a - CORRECT ANSWER:

frost knot

Accessory cord used in the construction of a load releasing hitch can be - CORRECT

ANSWER: either 8mm or 9mm

All equip. that falls 3 ft onto a hard surface shall be checked for: - CORRECT ANSWER: Burs, sharp edges, dirt, contaminates, lose parts and deformaties

All harness construction and testing standards are covered in NFPA: - CORRECT

ANSWER: 1983

All riggin shall have how many checks prior to Loading? - CORRECT ANSWER: 3

Besides a minimum diameter of 11mm G rated rope, NFPA requirements also call for -

CORRECT ANSWER: Rope diameter, elongation, minimum temperature

Besides holding or capturing a load line, prusiks are used for: - CORRECT ANSWER: Self-rescue

Braided ropes are/have: - CORRECT ANSWER: easy to pick bundles in soft braids

• / 3

Carabiners used in fall protection equipment designed for tower climbing shall per OSHA be designed with: - CORRECT ANSWER: A self closing self locking design

Care and maintenance of all rescue equipment should be per: - CORRECT ANSWER: the helmet's manufacturer recommendations

Chemicals and sunlight will cause rope to - CORRECT ANSWER: change color and

fade

Class three harnesses are: - CORRECT ANSWER: Designed to keep the rescuer or victim in an up-right position

Engineered shock absorbing equipment is recommended by NFPA anytime there is a

potential fall factor greater than - CORRECT ANSWER: .25

Examples of mechanical belay devises include all of the following except: - CORRECT

ANSWER: HMS Munter carabiner

Examples of natural fiber ropes include: - CORRECT ANSWER: Cotton, sisal , manila

Fibers that run parallel in the core of a kernmantel rope will create a - CORRECT

ANSWER: Static rope

Hasty harnesses are very constrictive in nature and when placed on an individual can fall off if not under load or secured over the shoulders and they - CORRECT ANSWER: do not have a classification

Helmets used for rope rescue should be: - CORRECT ANSWER: Lighter in weight

If a rescuer falls 1 foot on 1 foot of slack in a belay line he will: - CORRECT ANSWER: Need engineered equipment to absorb the energy of the fall

• / 3