1 ....COPYRIGHT ©️
NCCCO TEST 2
AND ANSWERS
When making a multiple crane lift, it is important for the operator to understand
that: - ANSWER-The weight may increase if the other crane lands the load
If a crane is not set-up level and the operator swings a load from the high side to
the low side, the load radius will: - ANSWER-Increase
Most crane manufacturers reduce load capacity for duty-cycle operations because: - ANSWER-Side loading forces may occur On who's recommendations should a preventative maintenance program be set- up? - ANSWER-Crane manufacturer What is the standard rope used on most cranes? - ANSWER-Right regular lay
The proper way to calibrate a boom angle indicator is: - ANSWER-Using a level,
raise the boom to horizontal and set the indicator at 0 degree.
The red area of an instrument gauge means: - ANSWER-A dangerous condition
exists 1 / 2
2 ....COPYRIGHT ©️
The best way to keep people from being injured from the counterweight of the
crane is to: - ANSWER-Fence or barricade the swing area of the crane
Only approved attachments or extra counterweights made by the manufacturer
should be placed on the rear of the crane because: - ANSWER-They could cause a
backward stability problem What is the first thing an operator should do before going under a low pipe rack? - ANSWER-Post a signalperson to check clearance When working on outriggers, the only time they should be less than fully extended
is when: - ANSWER-There is a load chart for this operation
When lifting loads from the water, the operator should be aware that: - ANSWER-
The load will increase when you pick the load from the water What is require to be on a Hydraulic Crane in order for it to lift a man basket? - ANSWER-Boom length indicator When working on rubber, cranes are rated at what percentage of tipping? -
ANSWER-75%
When using cable or nylon spreaders, it is important to remember: - ANSWER-
The lower the spreader angle the greater the tension
Backward stability of a crane is tested with: - ANSWER-Basic boom at maximum
angle with maximum load
- / 2