1. The information within this study guide is intended to _

IMSA Roadway Lighting 1

• The information within this study guide is intended to _

roadway lighting systems and service.

• reduce the cost of
• highlight the importance of
• further knowledge and understanding of

D. define specifications for:

Answer C.

• The main purpose of lighting roadways and other transportation-relatedfacilities is to .

• provide an adequate visual environment for road users to safely use theroad system

during hours of darkness

• reduce crime
• improve economy

D. provide light on residential properties:

Answer A.

• It is the responsibility of those roadway lighting and

electricalsystems to determine the applicable standards and codes which apply to thegiven area, and incorporate the accordingly.

• purchasing
• operating
• using

D. designing:

Answer D.

• Regulations and standards for workers is defined by
• the employer
• the owner
• the U.S. Department of Labor - Occupational Safety & Health Administration(OSHA)

D. the National Electrical Code: 1 / 3

Answer C.

• The National Fire Protection Agency (NFPA) 70E - Standard for ElectricalSafety in the

Workplace covers the full range of electrical safety issues, including .

• safety related work practices
• maintenance
• special equipment requirements and installation

D. all of the above:

Answer D.

• As worker safety regulations and standards will vary from one area to another, it is the

responsibility of the to determine specific safetyrequirements for their area.

• employer
• regulatory agency
• employee

D. a and c:

Answer D.

• High visibility safety apparel .

• improves one's visibility to drivers thus reducing the risk of injury
• should be worn at night only
• is required only in major traffic volume areas

D. need only be worn in area where traffic speeds are over 30mph:

Answer A.

• When working near electricity shall be used for

protectionagainst electrical shock.

• any rubber glove
• common sense
• purpose designed protective rubber insulating gloves

D. the National Electrical Code: 2 / 3

Answer C.

• A worker should when working out of an aerial lift

truck.

• never wear a safety vest
• never wear a hardhat
• only secure only themselves against falling

D. secure their tools against falling:

Answer D.

• The person working on electrical systems should be .
• a qualified licensed electrician
• anyone who has read NEC
• someone with appropriate experience and training

D. a and c:

Answer D.

• It is best to never get close than from an overhead power

line(under 50kV).

• 5 ft
• 8 ft
• 10 ft

D. 1 ft:

Answer C.

• If your vehicle makes contact with an energized line, remain inside untilhelp arrives.

If you must get out due to fire, .

• jump our with your feet together, then shuffle away keeping both feet closetogether.
• get our anyway you can
• you must make sure you contact the vehicle and ground for safe exit

D. don't, it is best to wait for fire department:

Answer A.

• / 3