Certification Exam Latest Update Questions with Verified

NCCCO Articulating Crane Operator Certification Exam (Latest Update 2025 / 2026) Questions with Verified Answers | Grade A | 100% Correct

Question:

Before engaging the PTO you should ensure...

Answer:

all controls are in the off or neutral position and that all personnel are clear.

Question:

What should be the minimum safe distance around the work zone?

Answer:

minimum 10ft safe distance

• / 4

Question:

If a load area is not visible from your operator's position, what should you do?

Answer:

establish proper crane communication with a QUALIFIED signal person.

Question:

When operating at high boom angles, do not lower the extending boom because this can cause.....

Answer:

an overload situation

Question:

When operating at high boom angles, do not lower the extending boom because this can cause an overload situation, to prevent this you should do what instead?

Answer:

Retract the boom extensions first.

• / 4

Question:

What is a major cause of shock loading, and what should you do to avoid this?

Answer:

It is caused by jerking the controls to full speed or in a switch of directions.Instead, you should operate with smooth and gentle lever movements.

Question:

How would you minimize load swing?

Answer:

Position the boom tip directly over the load's center of gravity prior to lifting.

Question:

What do you do when releasing the manual extension boom (pins)?

Answer:

position the boom as flat as could be.

Question:

What do you do if the OLP engages?

Answer:

Operate any function that reduces the boom radius to continue. 3 / 4

Question:

What should you do if any doubt exists about the safety of a lift?

Answer:

consult your supervisor before handling the load.

Question:

Why are booms not side loaded? & what causes it?

Answer:

It can cause boom damage, collapse, or failure. It is caused by lifting out of level, dragging load, or operating in strong winds.

Question:

How do you check the hydraulics when a maximum rated load is handled?

Answer:

raising the load a few inches and checking for unintended slow lowering (aka boom drift).

• / 4