Certification Exam Practice Questions

Ohio Overhead Crane Operator Certification Exam Practice Questions And Correct Answers (Verified Answers) Plus Rationales 2025|2026 Q&A | Instant Download Pdf

• What is the primary purpose of a pre-operational crane inspection?
• To satisfy OSHA paperwork
• To ensure operator certification
• To verify safe crane condition before use
• To check job productivity

Rationale: Inspecting the crane before use ensures that it is safe and

operational, preventing accidents.

• When must a crane be taken out of service?
• When it has over 1,000 operational hours
• When any safety defect is found
• When the operator changes shifts 1 / 3

• After a monthly inspection

Rationale: Any safety defect must be corrected before the crane is

used to avoid hazards.

• Who is responsible for signaling during crane operations when a signal

person is required?

• The crane operator
• The designated signal person
• The supervisor
• The rigger

Rationale: A qualified and designated signal person directs crane

movements when necessary.

• What does the term "rated load" refer to?
• The weight of the slings
• The maximum load ever lifted by the crane
• The maximum allowable load the crane can safely lift
• The average load lifted

Rationale: Rated load is the manufacturer’s designed maximum safe

lifting capacity.

• Which of the following hand signals means to stop?
• Arm extended with palm down and move arm up
• Arm extended with palm down and move arm back and forth
• Both hands in fists
• Circular arm motion 2 / 3

Rationale: Standard crane stop signal is palm down, arm waving

horizontally.

6. If a load begins to swing, the operator should:

• Speed up the hoist
• Drop the load to the ground
• Stop and stabilize before continuing
• Rotate the boom to counteract

Rationale: Swinging loads are dangerous; stabilize before resuming

motions.

• Which condition requires immediate reporting and correction?
• Slight paint wear
• Broken or cracked hook
• Dirty controls
• Noise from wind

Rationale: A damaged hook is a major failure point and must be

repaired before use.

• What must be done before moving any load?
• Record load information
• Notify the entire worksite
• Ensure the load is properly secured and balanced
• Increase crane speed

Rationale: Unbalanced loads can shift or fall, so proper rigging is

essential.

• / 3