.png){kind=logo}
IMSA Signal Technician Level 1 End Chapter Questions
1. What is the primary function of the IMSA?:
Answer Safety education
- IMSA stands for::
Answer International Municipal Signal Association
3. Which of the following is NOT an IMSA certification?:
Answer
Y: Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
4. Which of the following are potential safety hazards?:
Answer Overhead and under- ground power Gas Aerial lift equipment
5. What are the sections of a ramp meter signal?:
Answer Circular red, circular green
- PPE stands for::
Answer Personal Protective Equipment 1 / 2
- Which of the follow is an example of adequate fall protection during the operation of
aerial lift equipment?:
Answer Full body harness Safety belt Rails of a platform lift
8. Work Zone Supervisor is responsible for which of the following tasks?:
Answer Ensure advance warning devices have not been removed or relocated
9. Which of the following is NOT a sentence type in the MUTCD?:
Answer
Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
Y: Support; additional information to clarify the standards and guidance
- Which of the following is an example configuration of an Emergency-Vehicle Traffic
Control Signals::
Answer Three-section traffic signal with circular red, circular yellow, and smaller circular yellow indications
- The following phases are typically assigned to the major street through movements::
Answer 2 and 6
12. The green interval is made up which three components?:
Answer Minimum green, passage time, maximum green
- What are the three types of recall features of a traffic signal controller?: -
- / 2
Answer Minimum, maximum, pedestrian (+soft)
.png)