Forging Endorsement Certification Exam

American Farrier’s Association (AFA) Forging Endorsement Certification Exam Practice Questions And Correct Answers (Verified Answers) Plus Rationales 2026 Q&A | Instant Download Pdf

1. In forging, the term “drawing out” refers to:

a) Expanding metal in width

b) Lengthening metal by hammering

c) Creating decorative relief

d) Bending metal to a curve

Rationale: Drawing out increases length while reducing thickness.

2. The tool primarily used to isolate material for a clip is:

a) Fuller

b) Rounding hammer

c) Creaser or clip starter 1 / 3

d) Hardy

Rationale: A creaser localizes material to pull it into a clip.

3. Steel changes to a plastic working state at approximately:

• 500°F
• 1,000°F
• 1,500–2,200°F
• 3,000°F

Rationale: This temperature range is where steel becomes workable

under the hammer.

4. The purpose of a pritchel hole in an anvil is to:

a) Hold tools

b) Bend steel

c) Split stock

d) Punch nail holes

Rationale: The pritchel hole allows material displacement in

punching.

5. When forging toe clips, the correct location is:

• 1/4” from the toe

b) Between the quarter and heel

c) At the center of the toe

d) On the quarter only

Rationale: Toe clips are centered at the toe for alignment and

stability. 2 / 3

• Which hammer face produces the least marking on hot steel?

a) Sharp cross-pein

b) Flat polished face

c) Roughened face

d) Straight pein

Rationale: A smooth, polished flat face leaves minimal surface

marking.

7. A hardy tool is used for:

a) Welding steel

b) Cutting metal on the anvil

c) Punching holes

d) Drawing steel out

Rationale: Hardies are bottom cutting tools used with a matching top

tool.

8. A properly forged nail crease allows nails to:

a) Sit above surface

b) Sit below hoof wall

c) Exit the wall at correct angle

d) Curl under the shoe

Rationale: Creasing sets nail pitch for correct exit line.

9. Best forging hammer weight for most farrier forging:

• 1 lb
• 5 lb
• / 3