• wonderlic tests
  • EXAM REVIEW
  • NCCCO Examination
  • Summary
  • Class notes
  • QUESTIONS & ANSWERS
  • NCLEX EXAM
  • Exam (elaborations)
  • Study guide
  • Latest nclex materials
  • HESI EXAMS
  • EXAMS AND CERTIFICATIONS
  • HESI ENTRANCE EXAM
  • ATI EXAM
  • NR AND NUR Exams
  • Gizmos
  • PORTAGE LEARNING
  • Ihuman Case Study
  • LETRS
  • NURS EXAM
  • NSG Exam
  • Testbanks
  • Vsim
  • Latest WGU
  • AQA PAPERS AND MARK SCHEME
  • DMV
  • WGU EXAM
  • exam bundles
  • Study Material
  • Study Notes
  • Test Prep

ground and test the brakes

Exam (elaborations) Dec 15, 2025 ★★★★★ (5.0/5)
Loading...

Loading document viewer...

Page 0 of 0

Document Text

Above utilities What is not a good location for crane set up - answer>>

If an operator arrives at a job site and the crane is already set up how would he Left the load a few inches off the checked the main an auxiliary breaks - answer>> ground and test the brakes

75% Tipping capacities for crawler cranes are based on - answer>>

If taking sides strain on a boom what concerns the operator the most - Boom damage answer>>

If a crane load chart has capacities listed in the shaded area this means that - If overloaded structural confidence will be compromisedanswer>>

As the layers of rope on a drum increase the allowable line Pull wil - Decrease answer>>

Of the following actions which one will most likely cause a side load condition - Abruptly starting or stopping the swinganswer>>

Cording to OSHA with any hook ball or attachment at its lowest point a minimum

  • of blank reps must remain on the drum at all times - answer>> 1 / 4

What is the minimum distance of crane must maintain from powerlines rated 10 feet below 50 KV - answer>>

What is the best procedures to follow if underground utilities are present - Contact utility company answer>>

For boom is reeves eccentrically to the block the most common result would be - Twisting of the boom answer>>

3.5-1 What is the safety factor for 6 x 19 IWRC wire rope - answer>>

5-1 What is the safety factor for rotation resistor wire rope - answer>>

>>5-1 What is the safety factor for rigging hardware - answer

What is the safety factor one hoisting personnel using IWRC wire Rope - >>7-1 answer

What is the safety factor hoisting personnel using rotation resistance wire rope - 10-1 answer>>

Unless the manufacturer states otherwise the wind speed to seize hoisting Shall be 30 mph - answer>> 2 / 4

20 When hoisting personnel OSHA requires wind speed not to exceed - answer>> mph

Who has the responsibility of determining the correct weight of the load - Supervisor answer>>

Land load engage all When an operator leave there a crane they must - answer>> locks and Pawls and lock machine

When is it safe to work closer than alarm for distance from any powerline - When the utility company certifies that the lines are D energized answer>>

When operating a crawler crane what is the most unstable allowable quadrant of Side operation - answer>>

The distance from the center of The term load radius is best defined as - answer>> rotation of the crane to the center of gravity of the suspended load

Should the load be applied when determining the proper boom angle - >>Yes answer

When telescoping the boom section of a rubber tire which section should be All sections should be telescoped equally telescoped first - answer>> 3 / 4

  • degrees Hooks must be discarded if a twist more than is found - answer>>

>>5° Hooks must be discarded if a throat opening of more than is found - answer

Wire rope must be removed from service if any of the following conditions exist - Six randomly distributed broken wires answer>> Wear of more than 1/3 of the outside diameter three broken wires and one strand of one lay length

When arriving first on the job site the operator should first determine the >>Access roads condition of the - answer

200% Basket hitch is rated of a vertical hitch - answer>>

How many broken wires must be present in one strand of one lay for running wire >>3 rope to be removed from service - answer

How many broken wires must be present in rotation resistant wire rope to be

  • in six diameters removed from service - answer>>

What is the minimum clearance needed between cranes counterweight and any

  • feet obstacle - answer>>
  • / 4

User Reviews

★★★★★ (5.0/5 based on 1 reviews)
Login to Review
S
Student
May 21, 2025
★★★★★

The comprehensive coverage offered by this document was incredibly useful for my research. A outstanding purchase!

Download Document

Buy This Document

$1.00 One-time purchase
Buy Now
  • Full access to this document
  • Download anytime
  • No expiration

Document Information

Category: Exam (elaborations)
Added: Dec 15, 2025
Description:

Above utilities What is not a good location for crane set up - answer>> If an operator arrives at a job site and the crane is already set up how would he Left the load a few inches off the checked ...

Unlock Now
$ 1.00