Millwright Interprovincial (Red Seal) Review Exam 3 Latest Update - Questions and 100% Verified Correct Answers
_______ roller spurs enter the main line conveyor at 90 degrees.
- Gravity
- Live
- Select
D) Actuated - CORRECT ANSWER: A) Gravity
. Worn ring grooves on an engine piston will cause:
- the rings to rock back and forth.
- combustion gases to blow by the rings into the crankshaft.
- oil consumption.
D) all of the above. - CORRECT ANSWER: D) All the above
- A ____ pitch is designed for the movement of free flowing material.
- double
- variable
- long
- half
E) short - CORRECT ANSWER: C) Long
- A dial indicator is used for aligning a piece of equipment. If the plunger rod extends
- positive
out of the dial a _____ reading is displayed.
B) negative - CORRECT ANSWER: B)Negative
- A relay coil has a single pole switch connected to the coil. The N.O. contact of the
- The armature is pulled towards the core and closes the contacts.
- The relay coil energizes, magnetizing the core.
- The initiating device is activated or closed.
- When the contacts close the lamp illuminates.
- The core attracts the armature.
relay is connected to a lamp. Place the following steps from the list below in order of occurrence (1 through 5) when energizing the circuit.
A) 1,3,2,4,5
B) 3,2,5,1,4
C)3,5,2,1,4
D) 2,3,1,5,4 - CORRECT ANSWER: B) 3,2,5,1,4
1. Case nut die should only be used to:
- produce extra fine threads.
- recondition threads. 1 / 2
- clean threads.
D) both B and C. - CORRECT ANSWER: D) both B and C
- Data from ultrasonic testing can be used to predict component failure.
- True
B) False - CORRECT ANSWER: A) True
- Depending on the type of sling and hook-up, the capacity of the double ply sling may
be 140 to ____% of the capacity of single ply.
A) 500
B) 325
C) 200
D) 150 - CORRECT ANSWER: C) 200
- During housing inspection while installing bearings, if the bore does not have any
- 1
visible damage, the bore should measure out to an accuracy of ___inch?
B) 0.1
C) 0.01
D) 0.001 - CORRECT ANSWER: D)0.001
- For every 20 degree Celsius rise in temperature, the air has the ability to hold about
- two
- three
- four
_____ times as much moisture.
D) five - CORRECT ANSWER: A) Two
- How is efficiency found?
- output over input
- input over output
- output times input times 100
D) output times input divided by hp - CORRECT ANSWER: A) Output over input
- How many styles of milling cutter are there?
- 5
- 4
- 3
D) 2 - CORRECT ANSWER: B)4
- If a four-leg bridle hitch is used to lift a load, often two legs are supporting the weight
while the other two legs:
- are used to offset inertia.
- balance the load.
- are backup encase of breakage.
- complete the WCB requirement - CORRECT ANSWER: B) balance the load.
- / 2