NCCCO CORE EXAM QUESTIONS AND CORRECT

NCCCO CORE EXAM QUESTIONS AND CORRECT

ANSWERS 100% PASS ( - ) GRADED A+

Unless the manufacturer states otherwise the wind speed to seize hoisting Shall be 30 mph

When hoisting personnel OSHA requires wind speed not to exceed 20 mph

Who has the responsibility of determining the correct weight of the load Supervisor

When an operator leave there a crane they must Land load engage all locks and Pawls and lock machine

When is it safe to work closer than alarm for distance from any powerline When the utility company certifies that the lines are D energized

When operating a crawler crane what is the most unstable allowable quadrant of operation Side

What is not a good location for crane set up Above utilities

1 1 / 4

Eccentric main boom reeving can cause Twisting of the boom

When putting wire rope on a drum the rope can be spoiled to within of the top of the drum  Half an inch

To prevent unauthorized access to the cranes working area though needs to be barricaded Working radius

What is the minimum distance from the cranes counterweight and any obstacle 2 feet

Which of the following weather conditions could restrict or stop hoisting activities Wind gusts

Rigging hooks must be discarded if the throat opening is increased by more than 5%

A crane performing personal lifts must not exceed of its rated capacity

50%

A luffing jib on a conventional or hydraulic crane will

2 2 / 4

Boom up or down independently of the main boom

On a crane off level by 1% with a main boom height of 100 feet the whip line would be off-center by  12 inches////12 inches for every 1° for 100 feet

The crane center of gravity were very the most swinging from the rear to the side with what type of crane Truck crane

When is sideload is introduced to a lattice boom what part of the boom would encourage the highest stress Boom tip

Voice signals must include Function and direction Distance and speed Function and stop

When assembling or disassembling a lattice boom when is it permissible to work under the boom When the AV Director shows it is in feasible not to and the limits time and movement////safe=never only when says permissible

What was the result of boom deflection be Increased Boom radius

3 3 / 4

When a crane is out of level by 1° it will lose the most capacity at what configuration Long boom minimum radius

What is the purpose of using a spreader beam Support long hard to control loads

Which of the following actions is most likely to cause two blocking Telescoping the boom out

When is it safe to handle loads under powerlines The load knows where any part of the crane can come closer than regulations allow

When working your power lines tag lines and slings should be constructed of Probably propylene or polyethylene and webbing because they offer a fair insulating property

When reading a load chart the listed capacity has an Asterix next to it this means The capacities are based on the crane structural competence

Pick can be made with the intermediate outriggers If there is a load chart for intermediate Outrigger work

• / 4