NCCCO CORE Questions 100 Correct

NCCCO CORE Questions | 100% Correct Answers | Verified | Latest Version

Before leveling a mobile crane on outriggers, an operator should ensure: - ✔✔there is no weight of the crane bearing on any tires

Operating a mobile crane with a long boom, on uneven ground, what support condition should be considered? - ✔✔Keeping 90 degree angle between cylinder rod and pad

What is the primary purpose fir a rooster sheave or auxiliary boom point sheave? - ✔✔Separate the boom hoist lines

How many randomly broken wires in a lay length must there be on a mobile cranes hoist line, before it should be removed from service? - ✔✔6

On a mobile crane, how many broken wires are permitted at the end connection of a pendent before it must be taken out of service? - ✔✔1

Type 1 rotation resistant hoist wire rope has a design factor of: - ✔✔5 to 1

How many randomly distributed broken wires in rotation- resistant hoist wire rope are considered for replacement? - ✔✔2 broken wires in 6 rope diameters

The term net capacity is best defined by which of the terms listed below? - ✔✔Gross capacity minus capacity deductions

Mobile cranes that are set up on barges, shall have a list chart provided by which of the entities listed below? - ✔✔Manufacturer

When lifting loads on tires, mobile cranes are rated at what percentage of tipping? - ✔✔75%

• / 2

How does the effective weight of a slowed extension relate to the actual weight of the extension? - ✔✔Higher than the actual weight.

When load radius is between radii values, the operator must use the: - ✔✔longer radius

Why should only approved attachments or extra counterweights provided by the manufacturer be placed on the rear of the crane? - ✔✔They could cause a backward stability problem.

A mobile crane's jib is offset 15º versus its original 0º offset, but the boom angle remains unchanged. In

this situation, the load radius: - ✔✔increases

Abruptly stopping a rapid swing on a long-boom mobile crane will produce what major effect? - ✔✔Collapsing the boom.

When determining the position to a mobile crane should be left in over night, when high winds in the

forecast the operator should: - ✔✔Follow the manufacturers recommendations.

If a mobile crane is NOT set-up level and the operator swings the load from the high side to the low side, what effect will that have on the radius? - ✔✔The radius increase.

Increasing the distance from the crane's center of gravity to the tipping axis will have what effect on the mobile crane? - ✔✔Decreases stability.

Backward stability of a mobile crane is tested in which configuration listed below? - ✔✔Basic boom at minimum angle with no load

Deflection of the boom while operating a mobile crane will increase? - ✔✔Load Radius (Swings out)

A sudden start or stop of the hoisting function while operating a mobile crane can produce a: - ✔✔dynamic load

Before lifting an occupied personnel platform on a job site, which of the following applies? - ✔✔Use 50% of rated capacity, Trial lift to anticipated weight, Ensure rigging dedicated to platform only.

• / 2