NCCCO OVERHEAD CRANE

NCCCO OVERHEAD CRANE

QUESTIONS AND C ORRECT

ANSWERS .

sound a warning signal - ANSWER- What should you do when the hook or load is moving above personnel?

specifically authorized by a responsible person - ANSWER- Cranes shall not be used for side pulls unless?

the switch or circuit breaker - ANSWER- According to OSHA, power supply to the runway shall be controlled by?

recommend safety - ANSWER- ASME B30 standards are designed to?

B30.2 - ANSWER- What is the ASME volume that pertains to overhead cranes?

shall not be used as an operating control - ANSWER- The hoist limit switch which controls the upper limit of the load block.. (finish phrase)

alloy - ANSWER- According to OSHA, what type of chain should be used by an overhead crane?

• / 2

wires in one lay - ANSWER- According to ASME B30.2, the removal criteria for regular lay wire rope is four broken wires in one strand, in one lay or twelve randomly distributed broken..(finish phrase)

1910.184 - ANSWER- Which OSHA regulation listed below can you find information about hoisting slings?

• 1910.184
• 1910.550
• 1910.180
• 1910.601

bridge travel - ANSWER- When given the signal (stop signal), what will the operator do?

lower to the floor and adjust the rigging - ANSWER- If the load does not balance after raising it off the floor, what steps should you take?

daily to monthly - ANSWER- According to OSHA, frequent inspections are to be performed at what intervals?

qualified engineer - ANSWER- If a crane is modified and re- it must be checked thoroughly by a?

• / 2