NCCCO OVERHEAD CRANE LATEST

1

NCCCO OVERHEAD CRANE LATEST

EXAM (ALREADY GRADED A+)

When using a remote or radio control, it is important to? - ANSWER-Change the battery at the beginning of shift

Before using rigging, the operator should be aware of the? - ANSWER-Lowest capacity rating

Overhead cranes should be parked in? - ANSWER-An area where it will not cause an unsafe condition

What should you do when the hook or load is moving above personnel? - ANSWER-Sound a warning signal

Cranes shall not be used for side pulls unless? - ANSWER- Specifically authorized by a responsible person

According to OSHA, power supply to the runway shall be controlled by? - ANSWER-The switch or circuit breaker

• / 3

2 ASME B30 standards are designed to? - ANSWER-Recommend safety

What is the ASME volume that pertains to overhead cranes? -

ANSWER-B30.2

82) The hoist limit switch which controls the upper limit of the load block? - ANSWER-Shall not be used as an operating control

According to OSHA, what type of chain should be used by an overhead crane? - ANSWER-Alloy

According to ASME B30.2, the removal criteria for regular lay wire rope is four broken wires in one strand, in one lay or twelve randomly distributed broken? - ANSWER-Wires in one lay

Which OSHA regulation listed below can you find information about hoisting slings?

• 1910.184 2 / 3

3

• 1910.550
• 1910.180
• 1910.601 - ANSWER-1910.184

If the load does not balance after raising it off the floor, what steps should you take? - ANSWER-Lower to the floor and adjust the rigging

According to OSHA, frequent inspections are to be performed at what intervals? - ANSWER-Daily to monthly

If a crane is modified and re-rated it must be checked thoroughly by a? - ANSWER-Qualified engineer

Who should establish a maintenance program for an overhead crane? - ANSWER-Manufacturer

When shall inspection of below the hook devices be performed? - ANSWER-During the shift

Which of the ASME standards listed are for below the hook lifting devices?

• / 3