NCCCO OVERHEAD EXAM QUESTIONS AND ANSWERS

1

1

NCCCO OVERHEAD EXAM QUESTIONS AND ANSWERS

When using a remote or radio control, it is important to?✓ change battery at beginning of shift

Before using rigging, the operator should be aware of the?✓ highest capacity rating

Overhead cranes should be parked in?✓ an area where it will not cause an unsafe condition

What should you do when the hook or load is moving above personnel?✓ sound a warning signal

Cranes shall not be used for side pulls unless?✓ specifically authorized by a responsible person 1 / 3

2

2

According to OSHA, power supply to the runway shall be controlled by?✓ the switch or circuit breaker

ASME B30 standards are designed to?✓ recommend safety

What is the ASME volume that pertains to overhead cranes?

✓ B30.2

The hoist limit switch which controls the upper limit of the load block.. (finish phrase) ✓ shall not be used as an operating control

According to OSHA, what type of chain should be used by an overhead crane?✓ alloy

According to ASME B30.2, the removal criteria for regular lay wire rope is four broken wires in one strand, in one lay or twelve randomly distributed broken..(finish phrase) 2 / 3

3

3 ✓ wires in one lay

Which OSHA regulation listed below can you find information about hoisting slings?

• 1910.184
• 1910.550
• 1910.180
• 1910.601

✓ 1910.184

When given the signal (stop signal), what will the operator do?✓ bridge travel

If the load does not balance after raising it off the floor, what steps should you take?✓ lower to the floor and adjust the rigging

According to OSHA, frequent inspections are to be performed at what intervals?✓ daily to monthly

If a crane is modified and re-rated it must be checked thoroughly by a?

• / 3