NCCCO PT Questions with 100 Verified Correct

NCCCO PT Questions with / Which unsafe condition could result when a wedge socket is attached directly to a load hook, using 6x19 IWRC?(A) Spinning of the load (B) Decreased line pull (C) Decreased safe working load (D) Structural failure

• (A) Spinning of the load

Which if the following will indicates intemal damage or ultimately core failure in rotation- resistant rope?(A) Strand bird caging (B) Dianeter reduction (C) Excessive lubrication (D) Kinking - (B) Dianeter reduction When a jib is erected from the stowed position and not used, how will its effective weight change?(A) It decreases (B) It increases (C) It will tip the crane (D) It stays the same - (B) It increases (45.When operating a telescopic boom crane equipped with an anti two-block prevention device, which hydraulic functions are disabled when the device is activated? (A) Winch down, boom up, and retract the boom. (B) Swing, Winch down, and raise the boom. (C) Hoist, extend the boom, and lower the boom. (D) Outrigger controls, retract the boom, and swing. - (C) Hoist, extend the boom, and lower the boom.

• A load applied at an angle to the vertical plane of the boom describes: (A) Over loading (B) Side

loading (C) Static loading (D) Angle loading - (B) Side loading

• Hand signals must be posted conspicuously: (A) In the vicinity of hoisting operations B. In the

drivers cab of the crane (C) In the office. (D) In the load chart - (A) In the vicinity of hoisting operations Which crane hand signal is illust ? (A) Retract the boom (B) Raise the boom (C) Extend the boom (D) Lower the boom - (C) Extend the boom the Power lines would be a big concern when considering a crane's set up location, another big concern could be? (A) Radio communication with signal person (B) Capacity of the crane (C) Gang members, crack heads, & tweakers (D) Voids, tanks, loose fill, & depressions - (D) Voids, tanks, loose fill, & depressions 1 / 2

• When inspecting the boom on a telescopic boom crane which item should be inspected? (A)

Float pads (B) Wear pads (C) Counterweight (D) Load block sheaves - (B) Wear pads Counterweight (A) when it's reeved over the main boom tip (B) when it's reeved over the auxiliary boom head (C) when it's on top of the boom (D) when it's reeved over the jib - C

• When a crane operator leaves the crane, the operator must first: (A) Disengage the PTO (B) Tum

the engine off (C) Land all suspended loads (D) Secure the area and lock out the controls. - C

• Cranes operating with long booms should be most concerned with winds coming from the: (A)

Rear of the boom (B) Side of the Boom (C) East (D) South. - (B)

• According to OSHA 1926 Subpart CC which of the following is prohibited with wire rope on a

crane? (A) Splicing (B) Cutting (C) Severing (D) Lubricating - (A)

• If a crane is not set-up level and the operator swings a load from the high side to low side, the

load radius will: (A) Increase (B) Decrease (C) Stay the same (D), Increase two feet for every one- degree out of level - (A)

• Side loading may be caused by: (A) Starting or stopping the swing too rapidly (B) Increasing the

load radius (C) Raising or lowering the boom too rapidly (D) Raising or lowering the load too rapidly - A

• According to OSHA 1926 Subpart CC, Who may perform a shift inspection on a mobile crane. (A)

A practical examiner (B) An A/D Director (C) A competent person (D) A qualified person - C

• According to OSHA 1926 Subpart CC what must be included in a monthly inspection? (A) Yearly

Inspection (B) A new hoist line (C) Outrigger report (D) Documented shift inspection - D

• According to OSHA 1926 Subpart CC, which of the following is included in a crane shift

inspection? (A) Waming decals (B) Ground conditions (C) Leaking exhaust (D) Hydraulic valves - (B)

• / 2