PA APPRAISERS LICENSE EXAM NEWEST

PA APPRAISERS LICENSE EXAM NEWEST

VERSION WITH 300+ ACTUAL EXAM

QUESTIONS AND CORRECT VERIFIED

ANSWERS/ PA APPRAISERS LICENSE REAL

EXAM WITH ANSWERS (GUARANTEED A+)

The auto appraiser considers the extent of damage, the size of the damaged area, and the appearance. Usually, if the repair cost exceeds ____ of the cost to replace the part, replacement is appropriate. - ANSWER-75%

The identifying marks on a plastic part are so worn down they cannot be read.Therefore, the plastic cannot be identified. Technician A says you can determine the type of plastic by cleaning an area of the damaged part and seeing if one of the plastic welding rods will stick to it. Technician B says you can determine the type of plastic by making small circular wafers from the repair materials and comparing their flexibility to the flexibility of the part being repaired. Who is right? - ANSWER-Both technicians are correct

Which of the following is used to form a seal and keep window glass in place in replacing the glass in a vehicle? - ANSWER-Filler strip seals the glass in place.The filler strip is inserted into the gasket.

A car has adjustable door hinges. There is a significant gap at the top of the front top and the bottom as well between the front fender and the windshield support column of the door. Technician A says the gap can be adjusted by repositioning the hinges. Technician B says the gap can be adjusted by shimming the hinges. Who is right? - ANSWER-Technician A is correct. Shimming the hinges would not lessen the door gap. Adjusting the hinges should solve this problem.

• / 4

When replacing a windshield, Technician A says that any caulking sealant can be used to hold the windshield in place. Technician B says that the windshield is a structural part in a modern vehicle. Who is right? - ANSWER-§ Technician B is correct. A windshield is considered a structural part and has certain requirements necessary to adhere to the pinchweld flange for strength. Windshields must be installed using urethane to restore the structural role of the glass.

Which emissions control system component introduces small amounts of exhaust gas into the intake manifold, where it is combined with the regular fuel mixture and diluted? - ANSWER-EGR Valve

What does PCV stand for? - ANSWER-Positive Crankshaft Ventilation

Which of the following refers to the forward or rearward tilt of the ball joints from a vertical position? - ANSWER-Caster

What are the most common types of calipers? - ANSWER-Fixed calipers and floating calipers

The device that synchronizes the spark plug firing sequence is: - ANSWER-

Camshaft sensor

Which one of the following answer choices list the two components that form the engine's combustion chamber? - ANSWER-Cylinder head and cylinders

Where is the driver's side air bag module located? - ANSWER-In the steering wheel

• / 4

What type of headlamp features a lens that is specifically designed for the auto model and contoured to its requirements for improved aerodynamics? - ANSWER- Composite

What tells the automatic transmission how fast the car is going? - ANSWER-The governor

Thermal Polyolefin plastic - ANSWER-TPO

In an automatic transmission, the shift lever connects to the: - ANSWER-manual

valve

Which part of the vehicle converts AC power to a direct current (DC)? - ANSWER-Alternator

How is a diamond condition fixed? - ANSWER-By pulling the damage for length.Diamond is a length condition.

When measuring a unibody vehicle, it is discovered that the left front rail is 111mm from spec in width. What condition is this? - ANSWER-Width is calculated from the center out, so a value of -111mm on the left rail shows sway to the right and in toward centerline.

A collision damaged vehicle is discovered to be down in height at opposite end of the center section. - ANSWER-Twist condition.

When diagnosing the damage to a full frame assembly on a sport utility vehicle, it is determined that the left side frame rail is higher than the right side frame rail.Technician A says the damaged state is known as a twist condition. Technician B says a sway condition exists. Who is right? - ANSWER-Tech A. When a frame 3 / 4

rail's relationship to the vehicle centerline is changed, such as pushed either to the left or right, the condition is known as sway. "Twist" is referred as the condition of the frame when entire sections are driven higher or lower than the opposite side.

Metal fillers contain different ingredients that provide fillers with special properties. - ANSWER-Fiberglass offers more resistance to moisture

HSLA - ANSWER-High Strength Low Alloy

When replacing the floor pan in the trunk area, what joint should be used to join the new pan to the existing floor? - ANSWER-An overlap joint

When acoustical foam is removed during the repair: - ANSWER-It must be

replaced with acoustical foam.

When setting up a three-dimensional measuring system, it should be setup on an undamaged area. - ANSWER-Starting in the center section is the correct method.

What is the plastic Black box in rear of the car? - ANSWER-Vapor Canister

Grinding or squeaking from wheel is a sign of what? - ANSWER-Bad Bearings

The insurance commissioner is responsible for everything except? - ANSWER- Endorsing an insurance company

How do you tell when a ball joint is bad? - ANSWER-Measure fixed points from knuckle to rotor

• / 4