QMED - OILER EXAM PREP ACTUAL

QMED - OILER EXAM PREP (ACTUAL / )

QUESTIONS AND VERIFIED ANSWERS.

If a bolt or stud were to break off flush at the surface, how do you remove it drill a hole in the center of the stud

The number of screw threads per inch for Standard National Coarse 1/2 bolt is 13

The A strake is adjacent to the keel

vertical transverse structures in the double bottom are known as floors

• / 4

the strake next to the keel is called the garboard strake

the garboard strake is located at either side of the keel

the end joint formed by adjoining plates in a hull plating strake is properly indentified as a butt

the welded joint located between two plates in the same strake of hull plating is called a butt

structural members used to support and transmit the downward force of the load and distribute that force over a large area are called pillars, columns, and stanchions

• / 4

vertical supports members used to support bulkheads are called stiffeners

the double bottom is a space comprised of compartments between the inner and outer bottoms

the purpose of swash bulkheads is to reduce liquid movement within a tank

in ship construction the hull frame members extending athwartship are called transverse frames

the inner bottom of a ship is the plating forming the engine room tank top

in a longitudinally framed ship, the longitudinal frames are held in place and supported by athwartship members called 3 / 4

web frames

the structural members of the hull extending in a fore and aft direction are called longitudinals

in merchant ship construction the term scantlings refer to beams, stiffeners, and shell plating

structural hull members installed athwartship are stringers

where should you expect to find striking plates at the bottom of the sounding tube

which gas is the most dangerous to personnel safety in confined spaces carbon monoxide

• / 4