TSS Mobile Crane Summer Exam

NCCCO Telescopic Boom Crane - Fixed Cab (TSS) Mobile Crane Summer Exam Review Questions and Answers 100% Pass When making a multiple crane lift it is important for the operator to

understand that: - Answer>>The weight may increase if the

other crane lands the load.If a crane is not set-up level and the operator swings a load from

the high side, the load radius will: - Answer>>Increase.

Most crane manufacturers reduce load capacity for duty-cycle

operations because: - Answer>>Side-loading forces may occur.

On whose recommendations should preventative maintenance

program be set-up: - Answer>>C rane manufacturer.

What is the standard rope used on most cranes? - Answer>>Right regular lay.

The proper way to calibrate a boom angle indicator is: -

Answer>>Using a level, raise the boom horizontal and set the indicator at 0º.

The red area of a instrument gauge means: - Answer>>A

dangerous condition exists.The best way to keep people from being injured from the counterweight of

crane is to: - Answer>>Fence or barricade the tail swing area of

the crane. 1 / 2

Only approved attachments or extra counterweights made by the

manufacturer should be placed on the rear of the crane because:

• Answer>>They could cause a backward stability problem.

What is the first thing an operator should do before going under a low pipe rack? - Answer>>Post a signal person to check clearance.When working on outriggers, the only time they should be less

than fully extended is when: - Answer>>There is a load chart for

this operation.When lifting loads from the water, the operator should be aware

that: - Answer>>The load will increase when you pick the load

from the water.What is required to be on a hydraulic crane in order for it to lift a manbasket? - Answer>>Boom length indicator.When working on rubber, cranes are rated at what percentage of tipping? - Answer>>75%

When using cable or nylon spreaders it is important to remember:

• Answer>>The lower the spreader angle to the horizontal, the

greater the tension.

Backward stability of a crane is tested with: - Answer>>Basic

boom at maximum angle with no load.If not listed in the load/capacity charts for the hydraulic crane and you are in between boom lengths, you should:: - Answer>>Use the next longer or shorter length (the lower capacity).

• / 2